Makita DCG140ZXK Instruction Manual page 9

ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
CAUTION:
Always place the tool on the
ground or workbench when carrying out any
assembling work. The tool without being held tight
may lose balance and cause injury.
Parts preparation
Optional accessory
The tool is composed of the following attachment parts
as shown in the illustration.
► Fig.7: 1. Holder joint 2. Plate 3. Piston 4. Holder
5. Rubber ring 6. Nozzle 7. Holder joint (as a
cap) 8. Rod
NOTE: Some attachment parts or optional accesso-
ries are not available in your country.
Prepare the proper type of attachment parts depending
on the caulking material container by referring to the
following table.
- 300 ml 400 ml
Holder
joint
Holder
joint A
Plate
Rod
Short rod
Piston
Piston A
Holder
Holder A Holder D
Rubber
ring
Nozzle
(Use the nozzle which is attached to the cartridge)
Holder Not
joint required
(as a
cap)
Cartridge
600 ml 800 ml
Holder joint B
Holder joint
C complete
(Holder
joint C +
Plate)
Plate
Black rod
Long rod
Piston D
Holder C
Holder B
Not required
Not required
Holder joint B
Holder
joint C
- 300 ml
(Not
available)
Holder -
joint
Plate -
Rod -
Piston -
Holder -
Rubber -
ring
Nozzle -
Holder -
joint
(as a
cap)
* The piston F pushes out the caulking material
leaner.
* When using the piston F, always use Makita noz-
zle. Using the nozzle any other than makita, may
cause an interference.
9 ENGLISH
Film package
400 ml 600 ml
Holder joint B
Holder joint
C complete
Plate
Short rod
Long rod
Piston B or Piston F *
Holder D
Holder B
Rubber ring for holder
joint B
Nozzle for holder joint B
Holder joint B
800 ml
(Holder
joint C +
Plate)
Black rod
Piston E
Holder C
Rubber
ring for
holder
joint C
Nozzle
for holder
joint C
Holder
joint C