Makita DCG140 Instruction Manual

Cordless caulking gun

Advertisement

INSTRUCTION MANUAL
Cordless Caulking Gun
DCG140
DCG180
013564
IMPORTANT: Read Before Using.
1

Advertisement

Table of Contents
loading

Summary of Contents for Makita DCG140

  • Page 1 INSTRUCTION MANUAL Cordless Caulking Gun DCG140 DCG180 013564 IMPORTANT: Read Before Using.
  • Page 2: Specifications

    ENGLISH (Original instructions) SPECIFICATIONS Model DCG140 DCG180 Max feed force 5000 N Feed speed 0 - 28 mm/s with short (300ml) holder 214 mm Stroke with long (600ml) holder 350 mm with short (300ml) holder 404 mm Overall length with long (600ml) holder...
  • Page 3: General Power Tool Safety Warnings

    EC Declaration of Conformity refrigerators. There is an increased risk of electric shock if your body is earthed or grounded. Makita declares that the following Machine(s): Do not expose power tools to rain or wet Designation of Machine: conditions. Water entering a power tool will Cordless Caulking Gun increase the risk of electric shock.
  • Page 4 Power tool use and care Service 17. Do not force the power tool. Use the correct 28. Have your power tool serviced by a qualified power tool for your application. The correct repair person using only identical power tool will do the job better and safer at the replacement parts.
  • Page 5: Functional Description

    Do not short the battery cartridge: FUNCTIONAL DESCRIPTION Do not touch the terminals with any conductive material. Avoid storing battery cartridge in a CAUTION: container with other metal objects such Always be sure that the tool is switched off and the •...
  • Page 6 Overloaded: • Overload warning lamp The tool is operated in a manner that causes it to draw an abnormally high current. 1. Warning lamp In this situation, release the switch trigger on the tool and stop the application that caused the tool to become overloaded.
  • Page 7 Lighting up the lamp NOTE: There types holders (optional • CAUTION: accessory), short holder (300ml) and long holder Do not look in the light or see the source of light directly. (600ml). Use appropriate holder joint accordingly. • Installing rod and piston 1.
  • Page 8 Installing holder 013567 Insert the cartridge into the holder as illustrated. 013561 Push the rod gently until the piston touches the bottom of the cartridge. To remove the cartridge, pull the rod backwards until it stops, then lift out the cartridge. Installing the cartridge into the long holder (600ml) 1.
  • Page 9: Operation

    NOTICE: Installing film type pack Clean the holder with appropriate solvent after • NOTICE: every day's work. Otherwise adhered caulking Make sure the piston B is attached to the rod. Do • material may cause tool breakage. not use other type of piston for film type pack. Film type pack can be installed in the long holder OPERATION •...
  • Page 10: Maintenance

    Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Piston A • Piston B • Piston C •...
  • Page 12 Makita Jan-Baptist Vinkstraat 2, 3070, Belgium Makita Corporation Anjo, Aichi, Japan www.makita.com 885260A229...

This manual is also suitable for:

Dcg180

Table of Contents