Preparation; Things To Be Done For Energy; Initial Use - Beko RDNE65X User Manual

Preparation

4
4.1. Things to be done
for energy saving
Connecting the product to electric
A
energy saving systems is risky
as it may cause damage on the
product.
Do not leave the doors of your refrigerator open
for a long time.
Do not put hot food or drinks in your refrigerator.
Do not overload the refrigerator, cooling capacity
will fall when the air circulation inside is
hindered.
In order to store maximum amount of food
in the freezer compartment, the icematic,
available in the freezer compartment and easily
removable by hand, shall be taken out. Net
volume and energy consumption values declared
on the power data plate of your refrigerator
are measured and tested by removing the
icematic. Do not remove the shelves inside the
freezer compartment and on the door of freezer
compartment shall not be removed and they
shall always be used they provide ease of use
and efficiency in energy consumption.
Airflow should not be blocked by placing foods
on the sides of the freezer compartment fan. A
minimum distance of 3 cm shall be provided on
the sides of protective fan cover.
The baskets/drawers that are provided with the
chill compartment must always be in use for
low energy consumption and for better storage
conditions.
Food contact with the temperature sensor in
the freezer compartment may increase energy
consumption of the appliance. Thus any contact
with the sensor(s) must be avoided.
Since hot and humid air will not directly
penetrate into your product when the doors are
not opened, your product will optimize itself
in conditions sufficient to protect your food.
Functions and components such as compressor,
fan, heater, defrost, lighting, display and so on
will operate according to the needs to consume
minimum energy under these circumstances.
Depending on the features of your product,
thawing frozen food in fridge compartment will
both provide energy saving and preserve the
food quality.
Do not allow contact of the food with the fridge
compartment temperature sensor shown in the
figure below.

4.2. Initial use

Before starting to use your refrigerator, ensure that
all preparations are made in accordance with the
instructions in sections "Instructions for safety and
environment" and "Installation".
Run the product without putting any food for 6
hours and do not open its door unless certainly
required.
C
You will hear a noise when the
compressor starts up. The liquids
and gases sealed within the
refrigeration system may also
give rise to noise, even if the
compressor is not running and this
is quite normal.
C
Front edges of the product may
feel warm. This is normal. These
areas are designed to be warm to
avoid condensation.
C
In some models, the instrument
panel automatically turns off
5 minutes after the door has
closed. It will be reactivated when
the door has opened or pressed
on any key.
12 /40 EN
Refrigerator / User Manual