Table of Contents
Advertisement
Quick Links
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
104cm
ASSEMBLY INSTRUCTION
SAN MARCO ELECTRIC LIFT CHAIR
ITEM CODE 60495
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
102cm
1
96cm
60495
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Amart Furniture SAN MARCO 60495
Summary of Contents for Amart Furniture SAN MARCO 60495
- Page 1 ASSEMBLY INSTRUCTION SAN MARCO ELECTRIC LIFT CHAIR ITEM CODE 60495 Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please phone Amart Furniture, Customer Service Free call 1800 351 084 102cm 104cm 96cm Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia. For any assistance with assembly or for missing parts please phone Amart Furniture, Customer Service Free call 1800 351 084 60495...
- Page 2 PRE‐ASSEMBLY PREPARATION Before you start: Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product Take care when lifting. Product should be assembled as near as possible to the point of use Ensure that you have all required contents for complete assembly Always read the assembly instructions carefully before beginning assembly.
- Page 3 PARTS LIST SUPPORT LEG 2 BOLT BUTTERFLY NUT TRANSFORMER POWER CORD REMOTE CONTROLLER 2 X 1 4 X 2 4 X 3 1 X 1 X 1 X 60495...
- Page 4 Step1: Make two bolts go through two holes of support leg and holes at rear bottom rail of mechanism. rear bottom rail same as another side support leg bolt bolt Step2: Screw two butterfly nuts on the bolts to fix support leg at rear bottom rail of mechanism. rear bottom rail butterfly nut 3 same as another side bolt 2 bolt 2 support leg 1 60495...
- Page 5 Step3: Connect power cord with transformer , then connect to interface of wire out from mechanism. Safety Note: Transformer is not to be placed under or within the recliner structure. power cord transformer wire from mechanism Step4: Connect remote controller to interface of wire out from mechanism. remote controller 60495...
- Page 6 Back‐up Power Option: This electric lift chair has been equipped with a Safety Battery Back‐up Option. This battery back‐up function is important to use when the electricity supply stops (power outage). Please ensure you place 2 X 9 volt batteries into the transformer piece during assembly. The battery back‐up will deliver enough power to return the lift chair back to the beginning position – please note that the batteries will only provide enough power for ONE MOTION back to the original position and is not for continued use. This is to ensure you are able to get out of chair safely in the event of a power outage. Please ensure to replace the batteries after each power outage event and use with the battery motion. 60495...
- Page 7 READ THESE INSTRUCTIONS THOROUGHLY BEFORE USE: DANGER: TO REDUCE THE RISK OF ELECTRIC SHOCK: Always unplug from electric outlet before cleaning. WARNING: RISK OF INJURY Keep children away from extended footrest and any moving parts. CAUTION: Do not allow children to play on this electric recliner or operate the powered mechanism.
- Page 8 60495...
Need help?
Do you have a question about the SAN MARCO 60495 and is the answer not in the manual?
Questions and answers