Samsung NX60 87 Series User Manual page 49

Problem Cause
The burners do not Surface burner
burn evenly. components and caps are
not assembled correctly
and level.
The surface burners are
dirty.
Very large or The wrong burner orifice
yellow surface is installed.
burner flames.
Surface burners The oven door lock is
light but oven turned on.
burners do not
light.
The Gas Pressure
Regulator shut off switch
is in the off position.
Action
See page 42.
Clean the surface burner
components.
(See page 41.)
Check the burner orifice size.
Contact your installer if you
have the wrong orifice (LP
gas instead of natural gas or
natural gas instead of LP gas).
The display will show the Lock
icon. Hold the oven door open
and Tap and hold START for
3 seconds. The oven will beep
and the Lock icon will turn off.
Call a qualified service
technician.
Oven
Problem Cause
The oven control There may be an issue
beeps and displays with your oven. See the
an information "Information codes" chart
code. on page 53.
The oven will not The oven is not
turn on. completely plugged into
the electrical outlet.
A fuse in your home
may be blown or the
circuit breaker may have
tripped.
The oven The oven thermostat
temperature is too needs adjustment.
hot or cold.
Action
Tap OFF, and then restart the
oven.
If the problem persists,
disconnect all power to the
range for at least 30 seconds
and then reconnect the power.
If this does not solve the
problem, call for service.
Make sure the electrical plug
is fully inserted into a live,
properly grounded outlet.
Replace the fuse or reset the
circuit breaker.
See page 34.
English 49