Table of Contents
Advertisement
CAMERA SETTING
For each camera connected to the unit, you can enter a camera title, such as the camera location, etc., that will be displayed together
with the picture from that camera. Also, each camera operating mode and timer recording mode can be set.
(CAMERA SET)
1
Press the MENU button 7 times to display the (CAMERA
SET) menu.
2
The following settings are available.
When finished, press the EXIT button to exit the
menu display.
Camera number
A
B
C
D
A
A camera title (up to 10 characters) to be displayed with
the live picture of the camera can be entered.
The camera title displayed location can be set in the
(DISPLAY SET) menu.
B
A day period and a night period can be set and the
following actions can be set accordingly.
B1: PROGRAM REC
Set to ON (or OFF) for programmed recording (or no
programmed recording) for each camera.
B2: AL. DURATION
Set the alarm duration for each camera.
B3: MON. MASK
Set to ON (or OFF) for each camera, so that the
image from that camera is greyed out (or is not greyed
out) and is not visible on the monitor.
Also, in the (MONITOR SET) menu, you must set the
monitor masking to be applied to live and/or recorded
monitoring.
B4: SEQUENCE
Set the sequential display interval for each camera.
C
VIDEO LOSS
Set to ON (or OFF), then in the (VIDEO LOSS SET)
menu set the "VIDEO LOSS" item to "INDIV." and enter
each setting. If the video signal is interrupted during live
picture mode, the image just previous to the interruption
is frozen on-screen or color bars can be displayed.
However, the frozen image and color bars settings
cannot be used together.
D
SENSOR SET
Sensor areas can be set for every camera screen in live
picture mode. By setting certain areas that operate as
video sensors, priority recording of the concerned
camera pictures can be done when a movement is
detected within the set sensor area.
A
Setting the camera title
Each camera is selected by pressing the appropriate SELECT
(1 – 9) button.
Example: To set the title "HALL-1F" for camera 3
1
Press the SELECT (3) button.
2
Using the + (or –) button set the first character "H", then
press the c button.
By pressing the + (or –) button repeatedly, the characters
are selected as follows:
•
Letters: A, B, C,....X, Y, Z
•
Numbers: 0, 1,....8, 9
•
Symbols: –, :, ., /, *, _ (blank space)
3
Following the same procedure, enter the rest of the title
"ALL-1F".
Press the MENU button to go to the next menu screen,
or
Press the EXIT button to exit the menu display.
12
36
Menu 7
3
English
Advertisement
Table of Contents
