Basic Operations; Mode Switching - Sanyo MPX-CD92 Instruction Manual

BASIC OPERATIONS

MODE SWITCHING

When the unit is connected to a power source, the default display mode will be as follows: live picture displayed in a 9
divisions split screen on monitor 1, and sequentially, full screen on monitor 2. You can use the VCR, MENU and LIVE buttons
to switch to the desired mode on monitor 1 (see below for further information). When the power is restored after having
already used the unit, the unit will restart in the modes selected before the unit was turned off.
LIVE picture mode
01 01 01 02 02 02
04 04 04 05 05 05
07 07 07 08 08 08
When the power on
Live Picture Mode
(see page 10)
When the LIVE button is pressed, the live (direct) picture from
the cameras connected to the camera input terminals (1 – 9) on
the unit rear panel, will be displayed on monitor 1. While in live
picture mode you can use the still and zoom functions.
NOTE:
• The unit will automatically start in the live picture or VCR
playback display mode (9, 4 divisions split screen, full screen
or sequential display) last selected. Therefore, when a mode
is selected, the display mode will remain the same.
•
If a camera is not connected at one of the input terminals,
"NO VIDEO" will be displayed on the monitor 1 screen.
VCR Playback Mode
(see page 18)
Start playback on the VCR. If the video signal is correctly
recorded, the VCR playback image will be displayed on monitor
1 when the VCR button is pressed. While in VCR playback
mode you can use the still and zoom functions.
NOTE: If playing back a tape not recorded through this unit,
"NO ID" will be displayed on the monitor screen.
NOTE: In live picture mode and VCR playback mode
there may be a slight vertical roll of the picture.
VCR playback mode
03 03 03 01 01 01 02 02 02
06 06 06 04 04 04 05 05 05
09 09 09 07 07 07 08 08 08
VCR
LIVE picture mode
03 03 03 01 01 01 02 02 02
06 06 06 04 04 04 05 05 05
09 09 09 07 07 07 08 08 08
LIVE
Menu Setting Mode
1
Press the MENU button to display the menu
The buttons used for menu control are indicated below.
MULTI
ZOOM
2
NEXT button
To select a sub-menu (in the (CAMERA SET), (POSITION SET),
(DISPLAY SET) menus) in order to set the title position, etc.
Press the NEXT button to switch between the menu and the
sub-menu.
3
j, l, c, d buttons...press repeatedly
• j button: will move the cursor up.
• l button: will move the cursor down.
•
c button: will move the cursor towards the right.
• d button: will move the cursor towards the left.
4
EXIT/DISPLAY button (see page 9)
To exit the menu mode and return to live picture mode.
Also, when in live picture mode or VCR playback mode, press
this button to switch the display of the camera title and the clock
display on/off.
5
+, – buttons...press repeatedly
•
+ button: for forward selection of numbers, letters,
symbols.
•
– button: for backward selection of numbers, letters,
symbols.
8
Menu mode
03 03 03
06 06 06
09 09 09
MENU
(see page 25)
1 2 3
MENU
LIVE VCR
ALL
NEXT RESET
MENU
EXIT
RESET
STILL SEQUENCE
– +
DISPLAY
4 5
English