Resolving Problems - Profile 545144224 User Manual

545144224

RESOLVING PROBLEMS

This device should only be repaired or disassembled by a qualified person. If problems persist, contact
the manufacturer. Improper repair will void the warranty and may cause the device to malfunction,
resulting in injury and property damage. Only use the device according to the instructions in these
operating instructions and only perform the operations advised here.
PROBLEM
The device does not
work.
The cooling or
heating effect is
insufficient.
The device is leaking.
MONOBLOCK AIR CONDITIONER
REASON
There is no electricity.
Ambient temperature is too
low or too high.
In cooling mode, the room
temperature is lower than the
desired temperature;
heating mode, the room
temperature is higher than
the desired temperature.
In dehumidification mode, the
ambient temperature is low.
There is direct sunlight.
Doors or windows are open;
there are many people in the
room; or in cooling mode,
there are
other heat sources present in
the room.
The grilles are dirty/clogged.
The air inlet or outlet is
blocked.
The device is skewed.
The drain pipe is blocked.
SOLUTION
Make sure the plug is in the socket and
that the socket is working normally.
Use the machine
temperature between 7 and 35°C.
Reset the desired room temperature.
in
Make sure the room temperature is higher
than 17°C
dehumidification mode.
Use curtains to reduce heat from the sun.
Close doors and windows; increase air
conditioning power.
Clean the grates.
Make sure there are no blockages, check
that the device was installed according to
the instructions.
Use a level to verify that the unit is hanging
straight. If not, remove the unit from the
wall and reinstall.
Check the drain pipe for blockages.
EN
only at room
when using the
16