Table of Contents
Advertisement
Installation
B
WArNING:
must be replaced by the Authorised
Service Agents.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be
connected to the mains supply via a suitable
switched and fused socket in a readily
accessible position.
Should the mains lead of the appliance
become damaged or need replacing at any
time, it must be replaced by a special purpose
made mains lead which can only be obtained
from a Authorised Service Agent.
B
WArNING:
earthed.
If the fitted moulded plug is not suitable for
your socket, then the plug should be cut off
and an appropriate plug fitted.
Destroy the old plug, which is cut off as a plug
with a bared cord could cause a shock hazard if
inserted into a socket elsewhere in the house.
The moulded plug on this appliance
incorporates a 13A fuse. Should the fuse need
to be replaced an ASTA approved BS1362 fuse
of the same rating must be used. Do not forget
to refit the fuse cover. In the event of losing
the fuse cover, the plug must not be used until
a replacement fuse cover has been fitted.
Colour of the replacement fuse cover must be
the same colour as that visible on the pin face
of the plug. Fuse covers are available from any
good electrical store.
Important
Fitting a different plug
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals on
your plug, proceed as follows:
Washing Machine /User's Manual
Damaged power cables
This appliance must be
1 Connect the green - yellow or green (earth)
wire to the terminal in the plug marked 'E'
or with the symbol f or coloured green and
yellow or green.
2 Connect the blue (neutral) wire to the
terminal in the plug marked 'N' or coloured
black.
3 Connect the brown (live) wire to the
terminal in the plug marked 'L' or coloured
red.
With the alternative plugs a 13A fuse must be
fitted either in the plug or adaptor or in the
main fuse box. If in doubt contact a qualified
electrician.
Transportation of the product
1. Unplug the product before transporting it.
2. Remove water drain and water supply
connections.
3. Drain all water that has remained in the
product. See 6.5
4. Install transportation safety bolts in the
reverse order of removal procedure; see 3.3.
C
Never move the product without
the transportation safety bolts
properly fixed in place!
A
WArNING:
are dangerous to children. Keep
packaging materials in a safe place
away from reach of the children.
Packaging materials
13 / EN
Advertisement
Table of Contents
