Advertisement
Install the Device/ 设备安装
D Ceiling-Mount/ 吊装
1
Place the mount in the desired installation
position.Use a marker to mark the screw
locations. Use an 8 mm drill bit to drill the
holes to a depth of about 42 mm. Use a
hammer to carefully drive the white plastic
expansion tubes into the holes.
将支架放置于安装位置 , 使用记号笔绘制螺钉
安装位置，选择直径为 8mm 的钻头，钻取深
约 42mm 的导孔。 使用羊角锤将白色膨胀管
打入钻好的孔内。
E Pole-Mount/ 立杆抱装
1
Install the wall-mount bracket to the pole-mount bracket.
将壁装支架安装到抱装支架上。
2
Use loops to install the pole-mount bracket to the pole.
使用抱箍将抱装支架安装到柱杆上。
2
3
Install the ceiling-mount bracket.
安装吊装支架。
3
Unfasten the screws on the universal joint to enable the universal joint
to rotate freely. Fix the shield on the universal joint, adjust the shield
position, and tighten all screws on the universal joint.
拧松万向节上的螺钉，使得万向节可以自由转动。将护罩固定到万向节上，调
整好护罩方位后，拧紧万向节上的所有螺钉。
Fix the box camera to the ceiling-mount bracket.
将枪机固定到吊装支架上。
4
F Beam-Mount/ 横臂抱装
1
Use a hold hoop to install the pole-mount bracket on the cross
arm (refer to step 2 in E Pole-Mount), install the universal joint
into No.2 hole on the pole-mount bracket, as shown in the
following figure (properly adjust the horizontal monitoring angle
during installation).
使用抱箍将抱装支架安装到横臂上（参见"立杆抱装中的步骤 2），然
后将万向节安装到抱装支架 2 号孔位（如下图，安装时注意调整好水平
监控角度）。
2
Unfasten the screws on the universal joint to enable the universal
joint to rotate freely. Fix the shield on the universal joint, adjust
the vertical monitoring angle, and tighten all screws on the
universal joint.
拧松万向节上的螺钉，使得万向节可以自由转动。将护罩固定到万向节
上，调整好垂直监控角度，拧紧万向节上的所有螺钉。
Advertisement
