Motorola APX 6000XE 1.5 User Manual page 31

You Hear Tone Name
Long, Medi- Volume Set
um-Pitched
Emergency Exit
Tone
A Group of Failsoft
Medium-
Automatic Call Back
Pitched
Keyfail
Tones
Console Acknowledge
Received Individual
Call
Site Trunking
Short, High- Low-Battery Chirp
Pitched
Tone
(Chirp)
Two High- GPS Fails
Pitched
Tones
Ringing Phone Call Received
Gurgle Dynamic Regrouping
Talk Permit
Unique, New Message
Low-Pitch-
ed Chirp
Unique, Priority Status
High-Pitch-
ed Chirp
Incremen- Bluetooth Paired
tal- Pitched
Bluetooth Connected
Tone
Decremen- Bluetooth Unpaired
tal- Pitched
Bluetooth Disconnec-
Tone
ted
A Group of Fall Alert Continuous
Very High- Tone
Pitched
Tones
Critical Fall Alert Con-
tinuous Tone
Unique Enhanced Zone Bank
Low-High Up
Tone
Heard
When volume is changed on a quiet channel.
When exiting the emergency state.
When the trunking system fails.
When voice channel is available from previous request.
When encryption key has been lost.
When status, emergency alarm, or reprogram request
ACK is received.
When Call Alert or Private Call is received.
When a SmartZone trunking system fails.
When battery is below preset threshold value.
When the GPS fails or loses signal.
When a land-to-mobile phone call is received.
(When PTT button is pressed) a dynamic ID has been
received.
(When PTT button is pressed) is verifying with the sys-
tem for accepting its transmissions.
When a new message is received.
When a priority message is received.
When Bluetooth accessory is paired with the radio.
When Bluetooth accessory is connected to the radio.
When Bluetooth accessory is unpaired from the radio.
When Bluetooth accessory is disconnected from the
radio.
When radio is in Fall Alert mode and prepares to trans-
mit Emergency Alarm when the timer of this alarm
ends.
When radio is in Fall Alert Enhanced mode and pre-
pares to transmit Emergency Alarm when the timer of
this alarm ends.
When EZB Up button is pressed to scroll the Enhance
Zone Bank up.
68012003047-HW
Chapter 4 : Status Indicators
31