Table of Contents
Advertisement
On vehicles with automatic transmission,
even if you turn off the overdrive switch
with the cruise control on, engine braking
will not be applied because the cruise con-
trol is not cancelled. To decrease the ve-
hicle speed, reset to a slower speed with
the cruise control lever or depress the
brake pedal. If you use the brake pedal,
cruise control is cancelled.
RESUMING THE PRESET SPEED
If the preset speed is cancelled by pulling
the control lever or by depressing the
brake pedal or clutch pedal, pushing the
lever up in the "RES/ACC" direction will
restore the speed set prior to cancellation.
However, once the vehicle speed falls be-
low about 40 km/h (25 mph), the preset
speed will not be resumed.
CRUISE CONTROL FAILURE WARN-
ING
If the "CRUISE" indicator light in the in-
strument cluster flashes when using the
cruise control, press the "CRUISE ON-
OFF" button to turn the system off and
then press it again to turn it on.
WWW.MANUALS.WS
If any of the following conditions then oc-
curs, there is some trouble in the cruise
control system.
A The indicator light does not come on.
A The indicator light flashes again.
A The indicator light goes out after it
comes on.
If this is the case, contact your Toyota
dealer and have your vehicle inspected.
WWW.MANUALS.WS
Clutch start cancel switch
(four-wheel drive models
with manual transmission)
To crank the engine without depress-
ing the clutch pedal, push the switch
with the ignition on.
The switch stays on as long as the ignition
is on. And it will automatically turn off
when the ignition is off.
This switch cancels the clutch start sys-
tem, which is designed to keep the starter
motor from operating if the clutch pedal is
not depressed all the way down.
The switch allows the vehicle to be driven
out of difficult situations by cranking the
engine with the clutch engaged.
83
Advertisement
Table of Contents
