Tips For Driving In Various Conditions - Toyota 4Runner 1996 Manual

Hide thumbs Also See for 4Runner 1996:
Table of Contents

Advertisement

(b) Starting the engine
Before starting the engine, be sure to fol-
low the instructions in "(a) Before crank-
ing".
Normal starting procedure
The multiport fuel injection system/se-
quential multiport fuel injection system in
your engine automatically controls the
proper air-fuel mixture for starting. You
can start a cold or hot engine as follows:
1. With your foot off the accelerator ped-
al, crank the engine by turning the key to
"START". Release it when the engine
starts.
2. After the engine runs for about 10 sec-
onds, you are ready to drive.
If the weather is below freezing, let the en-
gine warm up for a few minutes before
driving.
If the engine stalls...
Simply restart it, using the correct proce-
dure given in normal starting.
If the engine will not start—
See "If your vehicle will not start" in Part 4.
140
WWW.MANUALS.WS
NOTICE
A Do not crank for more than 15 sec-
onds at a time. This may overheat
the starter and wiring systems.
A Do not race a cold engine.
A If the engine becomes difficult to
start or stalls frequently, have the
engine checked immediately.
WWW.MANUALS.WS
Tips for driving in various
conditions
D Always slow down in gusty cross-
winds. This will allow you much better
control.
D Drive slowly onto curbs and, if pos-
sible, at a right angle. Avoid driving
onto high, sharp-edged objects and
other road hazards. Failure to do so
can lead to severe tire damage result-
ing in tire bursts.
D When parking on a hill, turn the front
wheels until they touch the curb so that
the vehicle will not roll. Apply the park-
ing brake, and place the transmission
in "P" (automatic) or in first or reverse
(manual). If necessary, block the
wheels.
D Washing your vehicle or driving
through deep water may get the
brakes wet. To see whether they are
wet, check that there is no traffic near
you, and then press the pedal lightly. If
you do not feel a normal braking force,
the brakes are probably wet. To dry
them, drive the vehicle cautiously
while lightly pressing the brake pedal
with the parking brake pulled. If they
still do not work safely, pull to the side
of the road and call a Toyota dealer for
assistance.

Advertisement

Table of Contents
loading

Table of Contents