Advertisement
EEI –1038
DINING CHAIR
Thank you for purchasing the MODWAY DINING CHAIR!
Before you start, here is some helpful advice:
1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step
instructions.
2.Owing to the size and weight of the dining chair, we recommend that it is assembled by two adults, on a
carpeted or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.
3.Please do not use any tools other than those provided or recommended in these instructions.
4.Please do not throw away any of the packaging or instructions until you have checked all the components and
hardware and the furniture is fully assembled.
5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the
components from time to time, so please save the tools that have been provided.
6.Please keep all pieces out of reach of small children.
Component:
1
Chair Body
x1
Customer Service 908-368-1025︱www.modwayfurniture.com
2
2
Left Front Leg x1
Hardware:
A
B
C
D
E
1
4
4
3
3
Right Front Leg
x1
Bolt M8x50mm
x 4
Bolt M8x65mm
x 4
Spring Washer M8
x 8
Flat Washer M8
x 8
Allen Wrench
x 1
4
Back Leg
x2
Page 1 of 3
Advertisement
Table of Contents
Related Manuals for modway EEI-1038
Summary of Contents for modway EEI-1038
- Page 1 EEI –1038 DINING CHAIR Thank you for purchasing the MODWAY DINING CHAIR! Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions.
- Page 2 EEI –1038 DINING CHAIR STEP 1: Please put the Chair Body (1) upside down on a carpeted or padded area. Then open the zipper on the bottom of Chair Body (1), to make the inside of the Chair Body(1) fully visible. Insert the Left Front Leg (2) into the right bottom hole on the Chair Body (1) as shown.
- Page 3 EEI –1038 DINING CHAIR STEP 3: Carefully turn over the dining chair. Please put a heavy object or seat one adult on top of the Seat Frame (2) to pressure the chair for leveling. Fully tighten the Bolts (A&B) with Allen Wrench (E) . Assembly is completed.
Need help?
Do you have a question about the EEI-1038 and is the answer not in the manual?
Questions and answers