modway EEI-1045 Quick Start Manual

EEI-1045 CHAIR

Thank you for purchasing the MODWAY CHAIR!

Before you start, here are some helpful advice:

1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step

instructions.

2. Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted

or padded area, in the room that it is intended for. Approximate assembly time: 30 minutes.

3. Please do not use any tools other than those provided or recommended in these instructions.

4. Please do not throw away any of the packaging or the instruction until you have checked all the components

and hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

and environmentally friendly way.

5. Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten

the components from time to time, so please save the tools that have been provided.

6. Please keep all pieces out of reach of children.

1. Seat

Customer Service 609-256-9000︱www.modway.com

Right Armrest

Bolt M8x65mm

Flat Washer

Allen Wrench

Left Armrest

4. Back

Page 1 of 3

Table of Contents

Need help?

Do you have a question about the EEI-1045 and is the answer not in the manual?

Page 1 EEI-1045 CHAIR Thank you for purchasing the MODWAY CHAIR! Before you start, here are some helpful advice: 1. We suggest you spend a short time reading through this leaflet and then follow the simple step-by-step instructions. 2. Owing to the size and weight of the Chair, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for.
Page 2 EEI-1045 CHAIR STEP 1: 1. Please put Seat (1) stand upright down on a carpeted or padded surface as shown. 3. Attach the Left Armrest (2) to the left of the Seat (1) by using 2 pieces of Bolts (A) with 2 pieces of Flat Washers (B) and use Allen Wrench (C) to tighten Bolts (A) clockwise as shown.
Page 3 EEI-1045 CHAIR STEP 3: 1. Open the HOOK & LOOP on the fabric cover of the Back (4) as shown. 2. Attach the Back (4) to the back of the Seat (1) by using 2 pieces of Bolts (A) with 2 pieces of Flat Washers (B) and use Allen Wrench (C) to tighten Bolts (A) clockwise as shown.