Table of Contents
Advertisement
23 Network configuration
devolo dLAN 1000 mini
You can find out device information, such as
the firmware version used and the specific
MAC address, using the Display Options
button.
Furthermore, other options are available,
such as the following:
b
Turn off LEDs,
b
Disable data communication,
b
Activate/ deactivate power saving mode,
b
Assign device names,
b
Reset device to factory defaults
and
b
View manual for the dLAN device
The selected dLAN adapter can be removed
from the available dLAN network using Re-
move Device.
The above-mentioned setting options vary de-
pending on the function and features of your
device.
Error states of the adapter are displayed even
though the LED is switched off.
4.5 Activate encryption by means
of devolo Cockpit
If you are using dLAN devices without encryption
buttons, encryption can only take place through
devolo Cockpit.
Before the networking procedure, note the se-
curity IDs of all dLAN adapters. This unique
identifier of each dLAN device can be found on
the rating plate on the housing. It consists of 4
x 4 letters separated by dashes (e.g. ANJR-
KMOR-KSHT-QRUV). Ensure that all dLAN
adapters are connected to the mains supply and
computers or other network components as ap-
propriate.
Scan for local adapter
After devolo Cockpit is started, it starts by searching
for the dLAN adapter connected directly to your
computer.
Adding an adapter
Add all the dLAN devices you want to your dLAN
network by selecting the Add button. You will need the
16 digit security ID of the adapter, which can be
found on the label on the rear side of the housing.
Enter it now into the Security ID field and confirm
with OK. If a security ID is correct and the device can
Advertisement
Table of Contents
