ICON Health & Fitness PRO-FORM 635 User Manual page 2

TABLE OF CONTENTS
IMPORTANT PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
BEFORE YOU BEGIN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
HOW TO USE THE CHEST PULSE SENSOR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
OPERATION AND ADJUSTMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .9
HOW TO FOLD AND MOVE THE TREADMILL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .22
TROUBLE-SHOOTING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .23
CONDITIONING GUIDELINES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .26
PART LIST . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .27
ORDERING REPLACEMENT PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Back Cover
Note: An EXPLODED DRAWING is attached in the centre of this manual.
IMPORTANT PRECAUTIONS
WARNING:
To reduce the risk of burns, fire, electric shock, or injury to persons, read the
following important precautions and information before operating the treadmill.
1. It is the responsibility of the owner to ensure
that all users of this treadmill are adequately
informed of all warnings and precautions.
2. Use the treadmill only as described in this
manual.
3. Place the treadmill on a level surface, with at
least 2.5 m (8 ft.) of clearance behind it. Do not
place the treadmill on any surface that blocks
air openings. To protect the floor or carpet
from damage, place a mat under the treadmill.
4. When choosing a location for the treadmill,
make sure that the location and position
permit access to an electrical plug.
5. Keep the treadmill indoors, away from mois-
ture and dust. Do not put the treadmill in a
garage or covered patio, or near water.
6. Do not operate the treadmill where aerosol
products are used or where oxygen is being
administered.
2
7. Keep children under the age of 12 and pets
away from the treadmill at all times.
8. The treadmill should not be used by persons
weighing more than 115 kg (250 lbs.).
9. Never allow more than one person on the
treadmill at a time.
10. Wear appropriate exercise clothing when
using the treadmill. Do not wear loose cloth-
ing that could become caught in the treadmill.
Athletic support clothes are recommended for
both men and women. Always wear athletic
shoes. Never use the treadmill with bare feet,
wearing only stockings, or in sandals.
11. When connecting the power cord (see page 9),
plug the power cord into an earthed circuit.
When replacing the fuse, on ASTA approved
BS1362 type should be fitted to the fuse car-
rier. A 13 amp fuse should be used. No other
appliance should be on the same circuit.
PART LIST—Model No. PETL63510
To locate the parts listed below, refer to the EXPLODED DRAWING attached in the centre of this manual.
No. Qty. Description No. Qty.
1 1 Motor Belt 49 2
2 1 Pulley/Flywheel/Fan 50 1
3 4 Motor Nut 51 1
4* 1 Motor/Pulley/ 52 1
Flywheel/Fan 53 4
5 1 Incline Motor Bolt 54 4
6 1 Plastic Incline Motor 55 1
Spacer 56 1
7 1 Incline Motor 57 1
8 1 Stop Bracket 58 1
9 1 Small Nut 59 2
10 3 Star Washer 60 7
11 4 Thick Base Pad 61 1
12 1 Frame 62 5
13 1 Latch Assembly 63 1
14 1 Splitter 64 1
15 8 Incline Motor Nut 65 2
16 4 Hood Screw 66 1
17 4 Plastic Stand-off 67 1
18 1 Hood Bracket (short) 68 4
19 1 Hood Bracket (long) 69 6
20 2 Warning Decal 70 1
21 1 Reed Switch 71 1
22 1 Reed Switch Clip 72 5
23 1 Motor/Controller Wire 73 1
24 1 Controller 74 1
25 1 Electronics Bracket 75 2
26 1 Circuit Breaker 76 14
27 1 Receptacle 77 1
28 1 Grounding Nut 78 1
29 1 On/Off Switch 79 4
30 1 Inlet Bracket 80 1
31 1 Incline Leg 81 4
32 2 Frame Pivot Bolt 82 1
33 2 Frame Pivot Spacer 83 2
34 1 Upright Wire Harness 84 1
35 1 Front Roller Adj. Bolt 85 2
36 4 Roller Adj. Washer 86 2
37 2 Motor Tension Nut/ 87 1
Front Roller Nut 88 1
38 4 Motor Bolt 89 10
39 2 Cap Screw 90 1
40 1 Left Foot Rail Cap 91 1
41 2 Foot Rail 92 1
42 1 Front Roller/Pulley 93 1
43 1 Magnet 94 1
44 2 Platform Centre Screw 95 2
45 2 Isolator 96 1
46 4 Isolator Screw 97 2
47 15 Plastic Fastener 98 1
48 1 Shield 99 2
Description No. Qty. Description
Belt Guide 100 1 Allen Wrench
Book Holder 101 17 Screw
Front Belly Pan 102 1 Edge Trim
Power Supply 103 2 Extension Leg
Cable Tie Clamp 104 2 Upright Endcap
Cable Tie 105 1 Shock
Walking Belt 106** 2 Extension Leg
20" Wire Harness Assembly
Rear Roller 107 2 Pulse Bar Bolt
Belly Pan Spacer 108 2 Pulse Bar Washer
Rear Foot 109 1 Pulse Bar
Rear Foot Screw 110 1 Right Handgrip
Ground Wire 111 1 Audio Wire Nut
Ground Wire Screw 112 1 European Power Cord
Belly Pan 113 1 Rubber Ring
Rear Endcap 114 1 Interface Bracket
Rear Roller Adj. Bolt 115 1 Filter
Motor 116 1 Console Base Bottom
Latch Decal 117 2 Upright Endcap
Platform Screw 118** 1 Chest Pulse Sensor
Electronics Screw 119 21 Hood Bracket Screw/
Latch Catch Incline Shield Screw
Walking Platform 120 1 Rear Foot Spacer
8" Cable Tie 121** 1 Hand Weight Set
Jack 122 1 Left Handgrip
Motor Tension Bolt 123 2 Static Decal
Foot Rail Insert 124 1 Hand Pulse Wire
Short Screw 125 1 Choke Bracket
Console 126 1 Chest Pulse Strap
Choke 127 1 Ground Screw
Long Screw # 1 8" White Wire, 2F
10' iFIT.com Wire # 1 14" White Wire, 2F
Motor Bushing # 1 10" Blue Wire, 2F
Upright # 1 20" Wire Harness, 2F
Incline Leg Pivot Bolt # 1 8" Blue Wire, 2F
Motor Mount Isolator # 1 4" Blue Wire, 2F
Handrail Extension # 1 4" Black Wire, M/F
Wheel Bolt # 1 4" Black Wire, 2F
Console Base # 1 4" Green Wire, F/Ring
Motor Tension Washer # 1 8" Green Wire, F/Ring
Console/Latch Screw # 1 8" Green Wire, 2 Ring
Key/Clip # 1 User's Manual
Incline Motor Plate * Includes all parts in the box
Right Foot Rail Cap **For information about the optional
Motor Tension Bushing hand weight set, see page 21
Motor Hood # These parts are not illustrated
Front Wheel
Incline Motor Shield
Base Pad
12" Audio Wire
Upright Grommet
R0601A
27