Installation - Tripp Lite B156-004-HD-V3 Owner's Manual

Installation

Prior to installation, ensure your graphics driver is up to date by
installing the latest driver available. The MST hub is backward
compatible with most DisplayPort 1.1a equipment running
current graphics drivers. The feature set is limited to the
attached equipment's capabilities (e.g., you may be limited to
displaying in Clone / Mirror mode only). Compatibility with older
graphics cards is not guaranteed.
Make sure the power to all connected devices is turned off
prior to installation.
1. Connect the hub's built-in cable to the computer's
DisplayPort output.
2. Connect the included external power supply to the hub
and plug it into a Tripp Lite Surge Protector, Uninterruptible
Power Supply (UPS) or Power Distribution Unit (PDU).
The Power LED will illuminate green.
3. Connect a monitor to an available output port on the hub.
Note: The maximum distance between the hub and the connected
monitor must not exceed 15 ft. (4.6 m).
4. Repeat step 4 for each additional monitor you are connecting.
5. Turn ON the power to the connected monitors, then power
on the source. The port LEDs will illuminate orange to
indicate a signal is being received and video will appear
on the connected monitors.
6. Use your video card's display settings screen to adjust how
video is displayed on the connected monitors.
6