Table of Contents
Advertisement
AMI BIOS SETUP
These options specify the bus that the named interrupt request lines (IRQs) are used on.
These options allow you to specify IRQs for use by legacy ISA adapter cards.
Assign IRQ to PCI VGA Card : This setting specify the requirement of IRQ dedicated
for PCI VGA Card. The default setting is Yes.
To continue the 'Advanced CMOS Setup', please move your cursor downwards to seek
for other options.
AMI BIOS SETUP – PCI / PLUG AND PLAY SETUP
© 1997 American Megatrends, Inc. All Rights Reserved
PCI Slot3 IRQ Priority
PCI Slot4 IRQ Priority
DMA Channel 0
DMA Channel 1
DMA Channel 3
DMA Channel 5
DMA Channel 6
DMA Channel 7
IRQ3
IRQ4
IRQ5
IRQ7
IRQ9
IRQ10
IRQ11
IRQ12
IRQ14
IRQ15
Reserved Memory Size
Reserved Memory Address
PCI Slot1 / Slot2 / Slot3 / Slot4 IRQ Priority : Without prior definition from the system
board designer, the default settings of these fields are Auto. These options determine
if AMIBIOS should remove an IRQ from the pool of available IRQs passed to BIOS
configurable devices. The available IRQ pool is determined by reading the ESCD
NVRAM. If more IRQs must be removed from the pool, the end user can use these
PCI/PnP Setup options to remove the IRQ by assigning the option to the ISA/EISA
setting. Onboard I/O is configurable by AMIBIOS. The IRQs used by onboard I/O are
configured as PCI/PnP.
Auto
Auto
PnP
PnP
PnP
PnP
PnP
PnP
ISA/EISA
ISA/EISA
PCI/PnP
ISA/EISA
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
PCI/PnP
Disabled
C8000
AP-545L / 46
Available Options
4 Disabled
16k
32k
64k
-¯ : Sel
ESC : Exit
PgUp/PgDn : Modify
F2/F3 : Color
Advertisement
Table of Contents
