Table of Contents
Advertisement
Boot From Card BIOS : This option is predefined by the system board designer. The
default setting is Yes.
Try Other Boot Devices : This option is predefined by the system board designer.
The default setting is Yes.
S.M.A.R.T. for Hard Disks : This option is predefined by the system board designer.
The default setting is Enabled.
Quick Boot : Set this option to Enabled to instruct AMIBIOS to boot quickly when the
computer is powered on. This option replaced the old Above 1 MB Memory Test
Advanced Setup option. The settings are:
Setting
AMIBIOS test all system memory.
READY signal from the IDE hard disk drive. AMIBIOS waits for 0.5
Disabled
seconds after sending a RESET signal to the IDE drive to allow the IDE
drive time to get ready again. AMIBIOS checks for a <Del> key press and
runs WINBIOS Setup if the key has been pressed.
AMIBIOS does not test system memory above 1MB.
AMIBIOS does not wait up to 40 seconds for a READY signal from the IDE
Enabled
hard disk drive. If a READY signal is not received immediately from the
IDE drive, AMIBIOS does not configure that drive. AMIBIOS does not
wait for 0.5 seconds after sending a RESET signal to the IDE drive to
allow the IDE drive time to get ready again.
You cannot run WINBIOS Setup at system boot, because there is no
delay for the Hit <DEL> to run Setup message.
The Optimal and Fail-Safe default settings are Enabled.
BootUp Num-Lock : Set this option to Off to turn the Num Lock key off when the
computer is booted so you can use the arrow keys on both the numeric keypad and the
keyboard. The settings are On or Off. The default settings are On.
Floppy Drive Seek : Set this option to Enabled to specify that floppy drive A: will
perform a Seek operation at system boot. The settings are Disabled or Enabled. The
Optimal and Fail-safe default settings are Disabled.
Description
AMIBIOS waits up to 40 seconds for
AP-545L / 35
AMI BIOS SETUP
Advertisement
Table of Contents
