Lanner electronics AP-545L Manual page 48

AMI BIOS SETUP
Instant On Support : Set this option to Enabled to allow the computer to go to full
power on mode when leaving a power-conserving state. This option is only available if
supported by the computer hardware. AMIBIOS uses the RTC Alarm function to wake
the computer at a prespecified time. The settings are Enabled or Disabled. The default
settings are Disabled.
Green PC Monitor Power State : This option specifies the power management state
that the Green PC-compliant video monitor enters after the specified period of display
inactivity has expired. The settings are Disabled, Off, Standby, or Suspend. The default
settings are Disabled.
Video Power Down Mode : This option specifies the power management state that the
video subsystem enters after the specified period of display inactivity has expired. The
settings are Disabled, Standby, or Suspend. The default settings are Disabled.
Hard Disk Power Down Mode : This option specifies the power management state that
the hard disk drive enters after the specified period of display inactivity has expired.
The settings are Disabled, Standby, or Suspend. The default settings are Disabled.
Standby Time Out (Minute) : This option specifies the length of the period of system
inactivity when the computer is in Full-On mode before the computer is placed in
Standby mode. In Standby mode, some power use is curtailed. The settings are
Disabled, 1 Min, 2 Min, and all one minute intervals up to and including 15 Min. The
default settings are Disabled. This mode is a coverage of the length of period for the
system inactivity, from period of Full-On to Standby, and from Standby to Suspend
mode.
Suspend Time Out (Minute) : This option specifies the length of the period of system
inactivity when the computer is already in Standby mode before the computer is placed
in Suspend mode. In Suspend mode, nearly all power use is curtailed. The settings are
Disabled, 1 Min, 2 Min, and all one minute intervals up to and including 15 Min. The
default settings are Disabled.
Slow Clock Ratio : This option specifies the speed at which the system clock runs in
power saving modes. The settings are expressed as a ratio between the normal clock
speed and the power down clock speed. The settings are 1:1, 1:2 (half as fast as
normal), 1:4 (the normal clock speed), 1:8, 1:16, 1:32, 1:64, or 1:128. The default
setting is 1:1.
AP-545L / 42