Surefire FURY-DFT - Tactical LED Flashlight Manual

SPECIFICATIONS

	FURY-DFT
OUTPUT	18650: 1,500; 123A: 1,100 lumens
RUNTIME	18650: 3.5; 123A: 2.25 hours
PEAK BEAM INTENSITY	18650: 25,200; 123A: 16,700 candela
DISTANCE	18650: 315; 123A: 255 meters
CONSTRUCTION	Aluminum
FINISH	Mil-Spec Hard Anodized
WEIGHT (w/batteries)	6.5 oz (184 g)
LENGTH	5.6 in (14.2cm)
BEZEL DIAMETER	1.39 in (3.5cm)
BATTERIES	One SF18650B lithium-ion rechargeable (incl) or Two 123A lithium (not incl)
SWITCHING	Click tailcap

All performance claims tested to ANSI/NEMA FL1-2009 Standard.

*SF18650B battery required for 1,500 lumens output, 3.5 hours runtime, 25,200 candela and 315 meters beam distance

LOCKOUT TAILCAP (US PAT. RE40125)

Most SureFire illumination tools feature a lockout tailcap, which prevents accidental activation during storage or transport. The tailcap may need to be enabled prior to light operation.

To enable, rotate tailcap clockwise until tight.

To lock out tailcap, rotate counterclockwise until light will not activate when pushbutton is pressed.

LIGHT OPERATION

Press lightly for momentary or press fully to click for constant-on.

BATTERY REPLACEMENT

Most SureFire illumination tools ship preloaded with batteries. To load or replace batteries:

1. Unscrew tailcap counterclockwise and remove.
2. Remove old batteries and dispose of properly.
   
3. Insert two new 123A lithium batteries or one 18650 battery with the positive (+) terminal(s) oriented forward.
4. Replace tailcap by screwing on clockwise. Press pushbutton (with tailcap enabled) to test.

BATTERY INFORMATION & WARNINGS

For complete battery information and warnings, reference the enclosed BATTERY INFORMATION / WARNING insert in your illumination tool's original packaging or visit www.surefire.com/battery-warnings-handling

Use of substandard batteries can cause injury or property damage. Visit www.surefire.com/batterysafety.

BATTERY INFORMATION The FURY-DFT can be powered by two 123A primary batteries or one protected 18650 with a minimum 6 Ampere (A) discharge rate. Fully charged, protected non-SureFire branded 18650 batteries that have a maximum discharge rate of less than 6A may not allow the FURY-DFT to operate normally. Go to www.surefire.com to purchase a SF18650B which come standard with a minimum 8-10A discharge rate. NEVER use an unprotected 18650 in the FURY-DFT, as this can result in fire and/or venting.