Sensorsteam" Function; Steam Settings; Shot Of Steam Function - Bosch Sensixx'x TDi90 Operating Instructions Manual

4. "SensorSteam" function

After the initial heating, "SensorSteam" function switches
off the iron when it is left unattended, thus increasing
security and saving energy.
1 While the handle is gripped, the iron heats up. The
"SensorSteam" indicator lamp (2) will remain lit
continuously.
2 When the handle is released, the "SensorSteam"
function is activated. The "SensorSteam" indicator
lamp (2) will flash.

5. Steam settings

This iron generates steam by means of a built-in motor.
While the motor is working, the "MotorSteam" indicator
lamps (14) of the water tank come on.
The iron is equipped with a sensor and an electronic
system to adapt the amount of steam to the mode of use,
optimising both the ironing and the service life of the
appliance.
The steam mode can be selected by pressing the "SET"
button (3) successively. The iron runs through the
following cycle:
Steam mode
Medium
(continuous steam)
Maximum
(continuous steam)
Dry ironing
(ironing without steam)
Steam production can be controlled manually for steam
ironing only when necessary. Select dry ironing mode and
press the motor activation trigger (1*).

6. Shot of steam function

shot
Shot of steam can be used to remove stubborn wrinkles
or to press in a sharp crease or pleat.
1 Set the temperature control (13) to at least "●●".
2 Press the shot of steam button (6) repeatedly with
intervals of at least 5 seconds.
* Model dependent
Indicator lamp (4)
"eco"
(green)
"max"
(red)
off
7
BOS CH