Whirlpool AKZM 8080 User And Maintenance Manual page 14

BREAD/PIZZA FUNCTION SELECTION
Turn the "Function" knob pointer to the symbol
functions for "bread" and "pizza".
Bread
1. Turn the "Function" knob to the symbol
2. Press to select the function.
3. Turn the "Browse" knob to set the required temperature (between 180°C and 220°C) and confirm with
button .
4. Turn the "Browse" knob to set the required cooking duration and press
Pizza
1. Turn the Function knob to the symbol
proceed as follows:
2. Turn the "Browse" knob: "PIZZA" appears on the display.
3. Press to select the function.
4. Turn the "Browse" knob to set the required temperature (between 220°C and 250°C) and confirm with
button .
5. Turn the "Browse" knob to set the required cooking duration and press
MEAT PROBE (PROBE)
The meat probe supplied allows the exact temperature (up to 100°C) to be measured during cooking,
to ensure optimum cooking.
Based on the food being cooked, the required core temperature can be set.
It is very important to position the probe accurately in order to obtain perfect cooking results. Insert the
probe fully into the fleshiest part of the meat, avoiding bones and fatty parts (Fig. 1). For poultry, the probe
should be inserted sideways, in the middle of the breast, taking care to ensure the tip does not end up in a
hollow part (Fig. 2).
In the case of meat with very irregular thickness, check it is cooked properly before removing it from the
oven. Connect the end of the probe in the hole located on the right wall of the oven chamber.
Fig. 1 Fig. 2
Meat Probe Cooking Function
When the meat probe is inserted, cavity temperature is managed as defined for the selected function but
cooking process finish once the temperature measured reach the estimated meat probe target set by the
customer.
There isn't a specified menu for the meat probe cooking functions, but is always possible switch from a
traditional function to a "Meat Probe function" This occurs when the meat probe is inserted on.
An acoustic signal sounds when the meat probe is detected, and "PROBE" appears on the display for
3 seconds. The display then shows the current information again.
If the Functions knob is not turned to Standby or Lamp, the display shows the general information on
the cooking functions and the temperature set for the meat probe.
to access a submenu containing the automatic baking
: the display shows "BREAD" and AUTO alongside.
: the display shows "BREAD". To select the "PIZZA" function,
EN12
to start cooking.
to start cooking.