Pre-Run Machine Inspection; Starting Machine; Emergency Stop Procedures; Filling Solution Tank - Kärcher Windsor Chariot 3 iScrub 26 Operating Instructions Manual

Operations
Machine Operation

Pre-Run Machine Inspection

Do a pre-run inspection to find possible problems that
could cause poor performance or lost time from break-
down. Follow the same procedure each time to avoid
missing steps.
NOTE: Perform Pre-run Machine Check before
operating machine listed in Service Schedule in
Maintenance Section.

Starting Machine

FOR SAFETY: Before starting machine, make sure
that all safety devices are in place and operating
properly.
1. The operator should be on the pedal platform. The
throttle pedal must be in the neutral position.
2. Turn the machine power on by turning key switch
clockwise to the "ON" position.
3. Press the Drive Reset Directional Control Switch to
reset and set the intended direction for travel.
4. Press lightly on the throttle pedal with right foot.

Emergency Stop Procedures

1. Push in emergency stop button. This will also
engage the parking brake and cause the machine
to stop immediately.
20

Filling Solution Tank

FOR SAFETY: Before leaving or servicing
machine; stop on level surface, turn off machine
and remove key.
1. Turn the machine power off.
2. Remove solution cover.
3. Fill the solution tank with clean water, leaving
4. Measure the chemical into the solution tank. The
5. Replace solution tank cover.
Flammable materials can cause an explosion or
fire. Do not use flammable materials in the tanks.
Les matières inflammables peuvent provoquer une
explosion ou un incendie. Ne pas utiliser de
matériaux inflammables dans les réservoirs.
86395370 Operator Manual - Chariot 3 iScrub 26
enough room for the required amount of detergent.
The solution tank capacity filled to fill inlet is 25 gal-
lons (95 liters). The water must not be hotter than
140° F (60°C) to prevent damage to the tank.
solution cover is also a 2 oz. (60 ml) measuring
cup. Liquid chemicals should be added to the solu-
tion tank after filling with water. Dry chemicals
should be thoroughly mixed before being added
into solution tank. Commercially available, high
alkaline floor cleaners, are suitable for use in the
solution system.
NOTE: Read the chemical manufacturers
recommended proportion instructions.