Electrolux REX CA 962 ALU Manual page 9

Part 1 - INSTALLATION INSTRUCTIONS
- Remove the plug from the upper part of the ducting fan unit
(fig. 17), as it is not possible to insert the flange F with the
plug in place.
- Fit the flange F Ø120 or 150 mm (fig. 18), replace the plug.
· Air outlet directed to the right or left hand side (fig. 4a-b).
- Remove the four screws fastening the plastic frame, as shown
in fig. 16.
- Fit the ducting spigot R (fig. 19) and replace the four screws
removed as above.
3 - Fixing the chimney
a) Loosen the screws M fixing the two parts
of the chimney and pull the inner section I
(fig. 20) almost all the way out. Remove
the protective film P.
b) Rest the lower section of the chimney in its housing on
the top of the hood canopy. Lower the ducting fan unit
until it reaches the wall bracket S and fix it using the
screw H provided (fig. 21). Fit the cover D (provided)
on the wall bracket S (fig. 22).
c) Fix the chimney A to the hood canopy C using the four
screws provided (fig. 23).
d) Insert the transparent seal Q (provided), so as to elimi-
nate any play between the two parts of the chimney
(fig. 24). Lock the screws M.
e) Remove the support rod B.
S
A08_21
E
E
A08_23
18
S
21
E
E
23
19
H
22
24
Q
Q
A08_24
17
18
R
I
P
M
20
A08_20
D
A08_22