Table of Contents
Advertisement
Part 1 - INSTALLATION INSTRUCTIONS
3 - Fitting the hood canopy C to the wall
a) Remove the lower grill and the active
charcoal filter if present (see paragraph
on maintenance).
b) Fit the support rod B using the two
screws K (3,5x9,5) provided (fig. 8).
c) Hook the hood canopy C to the eye
bolts O fixed in holes 1 (fig. 9).
d) Adjust the support rod B so that it
pushes against the wall (fig. 10).
e) Adjusting position (fig. 11). There are
two adjustable hooks at the rear of the
hood, which can be used to adjust its
position as follows:
- Turn the screws L until the
position of screws N
coincides with the lower
access holes.
- Turn the screws N to adjust
the vertical and horizontal
position of the hood.
- Lock the screws L to fasten the hood against the wall.
- Insert the plugs T provided in the holes giving access to screws N.
L
N
T
L
N
T
A08_11
11
4.3 - Installation of the chimney A
No matter which type of installation is being used, any wooden shelves in the area
where the hood is to be fitted must first be removed, drilled and later replaced.
16
A08_08
8
O
O
L
N
B
K
S36_09
9
B
O
S36_10
10
Advertisement
Table of Contents
