Extron electronics DTP3 T 202 Setup Manual page 2

DTP3 T 202/DTP3 R 201 • Setup Guide (Continued)
NOTE:
One power supply is included with the transmitter and normally can power both units, if they are both from the
Extron DTP3 series.
Smooth
Ridges
SECTION A–A
Figure 3. Power Wiring Diagram
B Loop Out port (Tx) — Connect a display with an HDMI input to display the Input signal to the transmitter.
C HDMI Input (Tx) — Connect an HDMI cable between this port and the digital video source.
NOTE:
See the
D DTP3 RJ‑45 ports — Connect transmitter OUT to receiver DTP3 IN, using a twisted pair cable. Extron recommends using
the following practices to achieve full transmission distances and reduce transmission errors:
Use Extron XTP DTP 22 STP cable for the best performance. At minimum, Extron recommends 22 AWG, solid
•
conductor, STP cable with a minimum bandwidth of 500 MHz.
Terminate cables with sheilded connectors to the TIA/EIA‑T568B standard (see image below).
•
Limit the use of more than two pass‑through points, which may include patch points, and punch down connectors. If
•
these pass‑through points are required, use shielded couplers and punch down connectors.
ATTENTION:
• Do not connect these devices to a telecommunications or computer data network.
• Ne connectez pas ces appareils à un réseau de télécommunications ou de données
informatiques.
NOTE:
When using shielded twisted pair cable in bundles or conduits, consider the
following:
• Do not exceed 40% fill capacity in conduits.
• Do not comb the cable for the first 20 meters, where cables are straightened, aligned,
and secured in tight bundles.
• Loosely place cables and limit the use of tie wraps or hook‑and‑loop fasteners.
• Seperate twisted pair cables from AC power cables.
E RS‑232 ports — To pass serial or control signals, connect the host device to the transmitter and the peripheral device to
the receiver via the RS‑232 captive screw connectors on both units
(see figure 4 for wiring).
RS-232 Device Bidirectional
Transmit (Tx) Transmit (Tx)
Receive (Rx) Receive (Rx)
Ground(Gnd) Ground(Gnd)
RS‑232 Wiring Diagram
Figure 4.
F HDMI Output (Rx) — Connect a display with an HDMI input to view the transmitted digital image.
G Audio Output (Rx) — Connect a balanced or unbalanced audio device, such as an audio amplifier or powered speakers, to
the receiver via the audio captive screw connector (see figure 5 to wire analog audio output).
Tip
Ring
Sleeves
Tip
Ring
Balanced Audio Output
Figure 5. Balanced and Unbalanced Audio Output Wiring Diagram
2
POWER
A
12V
3/16"
A
(5 mm) Max.
LockIt™ Lacing Brackets on the next page to securely fasten HDMI connectors.
RS-232
No Ground Here
Tip
Sleeves
Tip
No Ground Here
Unbalanced Audio Output
--A MAX
Do not tin
the wires!
Pins:
TIA/EIA T
12345678
568 B
Pin Wire color
1 White-orange
Orange
2
3 White-green
4 Blue
5 White-blue
6 Green
7 White-brown
8 Brown
TP Wires