Viking VGIC245 Use And Care Manual page 31

TROUBLE SHOOTING GUIDE__---- FREESTANDING GAS RANGE ----
PROBLEM
5. Gas flows to bake/broil
burner but does not light.
6.
Fan motor does not operate
7.
Oven light does not operate
8. Oven light stays on.
9. Oven indicator light does
not come.
10. No spark at top burners
11. Delayed ignition on top
burner.
PROBABLE CAUSE
5A. Igniter position too far
From burner.
5B. Dirt or grease in orifice.
5C.Insufficient gas pressure.
5D.Gas supply.
6A.No power to the fan
motor.
6B. Defective fan motor
winding or frozen motor .
shaft.
. 7A. Burned out bulbs.
7B. Defective light switch
7C. Defective light socket.
8A. Defective light switch
9A.
No power to the indicator
Light.
9B. Defective indicator light. 9B. Check for 120VAC at the indicator
10A.No power
10B.Broken igniter
10C.Wire connection,
pinched wire.
10D.Valve switch
10E.Defective spark module. 10E.Replace spark module.
11A.Electrode position
11BClogged ports on burner. 11B. Clean or replace burner.
202 B
CORRECTION
5A.
Reposition igniter closer to the
burner.
5B. Clean the orifice.
5C.
Check for correct gas pressure
should be 5"WCP for natural gas or 10"
WCP for LP gas.
5D.
Check oven shut off valve located on
manifold.
6A.Check for 120VAC supplied to the fan
motor. If no voltage is present, check
selector switch for continuity and,
for broken wiring between the selector
switch and fan motor. If voltage is
present at the fan motor proceed to 6B.
6B. Check the motor winding for continuity.
Check for a frozen motor shaft and
check for broken wiring between the
motor and neutral terminal block.
7A. Replace bulb.
7B.
Check light switch contacts for
7C. Check for 120VAC at the light socket
terminals. If voltage is present, replace
the socket. If no voltage is present
for broken wiring between the light
switch and light socket.
8A.
Check light switch contacts for
Replace light switch.
9A. Check for broken wiring between the
thermostat and indicator and from the
indicator to the neutral terminal block.
terminal. If voltage is present, replace
the indicator.
10A.Check power source.
10B.Replace spark electrode.
10C Check connection between spark
electrode and spark module.
10D.
Check continuity on valve switch. If
Continuity replace switch. If continuity
Checks ok, check all wire connections.
11A.Align electrode with burner port.
bake/broil
. Pressure
the
the
check
continuity.
, check
continuity
no