Troubleshooting Guide; Technical Service - Heath Zenith DualBrite 4290 Series Manual

SYMPTOM POSSIBLE CAUSE
Light will not 1. Light switch is turned off.
come on. 2. Bulb is loose or burned out.
3. Fuse is blown or circuit
4. Daylight turn-off is in ef-
5. Incorrect circuit wiring, if
Light comes 1. Light control may be in-
on in daylight.
2. Light control is in Test
Light comes 1. Light control may be
on for no sensing small animals or
apparent automobile traffic (Reduce
reason. sensitivity).
Please call 1-800-858-8501 (English speaking only) for assistance before returning
If you experience a problem, follow this guide. You may also want to visit our Web site at:
www.hzsupport.com. If the problem persists, call* for assistance at 1-800-858-8501 (English
speaking only), 8:00 AM to 5:00 PM CST (M-F). You may also write* to:
HeathCo LLC
P.O. Box 90045
Bowling Green, KY 42102-9045
ATTN: Technical Service
* If contacting Technical Service, please have the following information available: Model
Number, Date of Purchase, and Place of Purchase.
Please keep your dated sales receipt, it is required for all warranty requests.
204093-02

TROUBLESHOOTING GUIDE

breaker is turned off.
fect (recheck after dark).
this is a new installation.
stalled in a relatively dark
location.
(Set control switch to an
ON-TIME position).

TECHNICAL SERVICE

product to store.
No Service Parts Available for this Product
SYMPTOM POSSIBLE CAUSE
Light stays 1. The sensor is pointed toward
on continu-
ously.
2. Light control is in Manual
3. Light control is in
4. Sensitivity is set too high.
Light flashes 1. Light control is in the Test
on and off.
2. Heat being reflected from
7
a heat source like an air
vent, dryer vent, or brightly
painted, heat reflective
surface (Reduce sensitivity).
Mode. (Switch to Auto.)
D B mode.
®
ual rite
(Reduce sensitivity.)
mode and warming up
(Flashing is normal under
these conditions).
other objects may be
affecting the sensor. (Re-
aim sensor.)