Remove The Solid-State Drive (Ssd) Module - Lenovo 16IAH7 Hardware Maintenance Manual

Step 2. Remove seven screws and then remove the battery pack.
Figure 5. Remove the battery pack
Screw specifications
M2 x L4
Go to https://support.lenovo.com/partslookup
part:
Battery pack

Remove the solid-state drive (SSD) module

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Remove one screw and then remove the SSD module by pulling it away from the slot.
Figure 6. Remove the SSD module by pulling it away from the slot
30
Hardware Maintenance Manual
Number of screws
7
to look up the Lenovo part number of the following replacement