Remove The Lcd Module - Lenovo 16IAH7 Hardware Maintenance Manual

Remove the LCD module

Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the acetate tape" on page 34
"Remove the D cover mylar" on page 36
Step 1. Peel off the tape. Peel off the two pieces of mylar and detach the main and auxiliary antenna
cables.
Figure 29. Peel off the tape, the mylar and detach the antenna cables
Step 2. Disconnect the sensor cable and the EDP cable from the system board and release the cables.
Figure 30. Disconnect the sensor cable and the EDP cable and release the cables
Step 3. Rotate the LCD module to an angle of more than 90 degrees and place the computer on a flat
surface as shown. Remove seven screws and then remove the LCD module.
44
Hardware Maintenance Manual