WAREMA Omnexo 1M230 UP Installation Instructions

Omnexo switch actuator
1M230 UP
Installation instructions
General information
Fig. 1 Omnexo switch actuator 1M230 UP
The Omnexo switch actuator 1M230 UP is a device for the
central operation of a sun shading drive.
Its compact design enables flush mounting in junction
boxes.
It is operated via the Omnexo
control system. The drives and switch actuator are supplied
with 230 V AC and those of the switch actuator with 24 V
DC.
The Omnexo switch actuator 1M230 UP functionality
can be set. The control behaviour can be adjusted to the
different requirements of the various products.
Controlling the light and load is not permitted and
will result in a device fault.
Intended use
The Omnexo switch actuator 1M230 UP is an electronic
device for controlling sun shading devices. The approval
of the manufacturer must be obtained for any use of the
device other than its intended purpose specified in these
instructions.
The sun shading actuator is intended for installation in
enclosed electrical operating facilities.
Safety instructions
W ARNING
The electrical installation (assembly)/
dismantling must be performed by a
certified electrician in accordance with
VDE 0100 and/or with the standards
and legal requirements pertaining to
the respective country. The electrician
must observe the installation notes and
instructions included with the electrical
devices supplied.
warema_2052437_alhb_en_v2•2023-04-01
W ARNING
If hazard-free operation cannot be
assumed, the device must not be started
or must be deactivated. This assumption is
justified if
 the housing or the connecting lines show
signs of damage
 the device is no longer working.
W ARNING
Switch off the operating voltage of the
Omnexo switch actuator 1M230 UP when
performing activities on the connected
products. Danger due to sudden
movements.
W ARNING
It is important to comply with the following
points in the interest of personal safety.
 Children may not play with the operating elements of
the control unit or the remote control. Store remote con-
trols out of reach of children.

Make sure that no persons or objects are in the path
of the driven parts (venetian blinds, external venetian
blinds, etc.).
 Disconnect the device from the operating voltage if
cleaning or other maintenance work must be per-
formed.
C AUTION
When using window drives, the installer
of the system must ensure that the
safety regulations and precautions
of DIN EN 60335-2-103 "Particular
requirements for drives for gates, doors and
windows" as well as ASR 1.6 "Windows, roof
lights, transparent walls" are observed.
W ARNING
The switch actuators may only be used
to control such window drives where the
movement of the window cannot cause any
injuries.
We reserve the right to make technical modifications
Valid from
1 April 2023
Keep for future use.
1