Table of Contents
Advertisement
Installation
Attaching the hood and motor
assembly to the wall
The chimney and chimney extension
are attached to the wall using 2 retain-
ing plates. The motor assembly is at-
tached separately using 4 screws.
To layout the loctaions for the plates
and motor assembly:
^ Draw a vertical line, centered on the
cooktop, on the wall where the hood
will be installed.
28
^ Mark the location of the 2 motor as-
sembly support screws S + 10
(260 mm) above the cooktop, and
15
4
/
" (125 mm) to the right and left
16
of the centerline.
^ Layout the location of the lower re-
taining plate screw directly on the
centerline, S + 19
above the cooktop.
^ Hold the upper retaining plate flush
against the ceiling so that the center-
line passes through the notch on its
lower edge. Making sure the plate is
level, mark the location of the 2
mounting screws.
1
/
"
4
1
/
" (495 mm)
2
Advertisement
Chapters
Table of Contents
