Related Manuals for Miele DA 289-3
Summary of Contents for Miele DA 289-3
- Page 1 Operating and installation instructions Ventilation System DA 289-3 To prevent accidents and machine damage, read these instructions installation or use. M.-Nr. 05 853 730...
-
Page 2: Table Of Contents
Main power switch ..........10 Turning on the fan . - Page 3 This appliance is intended for residential use only. Use the appliance only for its intended purpose. The manufacturer cannot be held responsible for damages caused by improper use of the hood. This appliance complies with current safety requirements. Improper use of the appliance can lead to personal injury and material damage.
- Page 4 However, under certain conditions it may be possible for an installation in these applications. Please contact the nearest Miele dealer or the Miele Tech- nical Service Department with specific requirements. Before servicing or cleaning the...
- Page 5 Never leave surface units unat- tended at high settings. Boilovers cause smoking and greasy spillovers may ignite. Heat oils slowly on low or medium settings. Always turn hood "ON" when cook- ing at high heat or when cooking flaming foods. Clean ventilating fans frequently.
-
Page 6: Important Safety Instructions
When installing the hood, make sure that a minimum safety dis- tances of 14 " is maintained between a Miele cooktop and the bottom of the hood. If local building codes require a greater safety distance, follow their require- ment. - Page 7 The ventilation hood works by air ex- traction. The air is drawn in through the air intake panel, cleaned by the grease filter and directed outside. The hood comes equipped with a . This flap automatically closes when the hood is turned off so that no exchange of outside air and room air can occur.
- Page 9 This button turns the light on and off and also dims the light. The lighting can be used independently of the fan. Four fan speed selection This button activates the Delayed Shut Down feature. The fan can be set to turn off automatically after either 5 or 15 minutes.
-
Page 10: Main Power Switch To "0
^ Remove the air intake panel to ac- cess the main power switch (see "Cleaning and Care"). ^ Press the main power switch to "I". The fan and lighting are ready to use. If the appliance is not going to be used for a long period of time (e.g. -
Page 11: Delayed Shut Down
If odors or smoke remain in the kitchen after cooking has been completed, the Delayed Shut Down feature can be se- lected to allow the hood to continue running for either 5 or 15 minutes. ^ Press the Delayed Shut Down button while the fan is still running. -
Page 12: Grease Filter Timer
A timer monitors the hours of fan opera- tion. The indicator for the grease filter will light after 30 hours of operation. The grease filter and air intake panel must then be cleaned. After the grease filter has been cleaned and put in place, the grease filter timer must be reset. - Page 13 The grease filter timer is preset to 30 hours. This time can be lengthened or shortened to 20, 30, 40 or 50 hours. – A time of 20 hours should be pro- grammed in kitchens with frequent pan or deep frying. –...
- Page 14 The reusable metal grease filter re- moves solid particles from the vented kitchen air (grease, dust, etc). The grease filter and the air intake panel should be cleaned every 3 - 4 weeks or whenever the grease filter in- dicator lights. Keep the grease filter clean to pre- vent a fire hazard.
-
Page 15: Cleaning The Casing
^ Clean the filter use a scrub brush in warm water with a mild detergent. place the filters in the lower basket, making sure that the spray arm is not blocked. Depending on the detergent, clean- ing the grease filter in a dishwasher may cause permanent discoloration of the filter surface. - Page 16 Before cleaning or servicing the hood, disconnect it from the power supply by either removing the fuse, unplugging it from the outlet or man- ually "tripping" the circuit breaker. Never use abrasive cleaners, scouring pads, steel wool or caustic (oven) cleaners on the hood. They will damage the surface.
- Page 17 ^ Pull the old bulb out of its socket us- ing the enclosed lever. Replace it with a new one. Be careful not to drop the bulb on the cooktop. Replacement bulbs may be ordered from Miele’s Technical Service De- partment. USA 1-800-999-1360 CDN 1-800-565-6435...
- Page 18 In the event of a fault which you cannot correct yourself please contact: – Your Miele Dealer – The Miele Technical Service Department 1-800-999-1360 techserv@mieleusa.com 1-800-565-6435 service@miele.ca When contacting the Technical Service Department, please quote the model and serial number of your appliance.
- Page 19 Installation instructions...
- Page 20 Installation instruction ..........28 Dismantling .
- Page 21 The cardboard box and packing materials protect the appliance during shipping. They have been designed to be biodegradable and recyclable. Please recycle. Ensure that any plastic wrappings, bags etc. are disposed of safely and kept out of the reach of children. Danger of suffocation! Old appliances may contain materials that can be recycled.
-
Page 23: Changing The Light Bulbs
prevent scratches to the chimney dur- ing installation. chimney extension. tional stability of the chimney. for securing the ducting. for use with 5" (125 mm) exhaust ducting. extraction only. Caution: During the installation pro- cess, please be careful of sharp edges that can cause harm. - Page 24 The majority of the weight of the in- stalled ventilation system will be supported by the lower retaining plate. It must be firmly attached to the stud framing behind the drywall. If studs are not available in the re- quired locations, a plywood backing (min.
- Page 25 If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele’s Tech- nical Service Department. 1-800-999-1360 1-800-565-6435 The hood comes equippped with a 5 ft (1.5 m) power cord with a NEMA 5-15...
- Page 27 Do not install this exhaust hood over cooktops burning solid fuel. When installing the hood, make sure that the ( ) between the top of a Miele cooktop and the bottom of the hood is at least 14 " (365 mm).
- Page 28 See the enclosed installation instruction sheet. Please read the "Important Safety In- structions" and Installation instructions before installing this hood. The casing is covered by a protective film to prevent scratches during trans- port. Peel off the film before installing the casing parts.
- Page 29 – Where the ductwork is horizontal, it must slope away from the hood at least " per foot (1cm per meter) to prevent condensation dripping into the appliance. – If the exhaust is ducted through an outside wall, a Miele Telescopic Wall Vent can be used.
- Page 30 – If the exhaust is ducted into an inac- tive flue, the air must be expelled parallel to the flow direction of the flue. Never connect an exhaust hood to an active chimney, dryer vent, vent flue, or room venting ductwork. Seek professional advice before connect- ing an exhaust hood vent to an exist- ing, inactive chimney or vent flue.
- Page 32 Alteration rights reserved /5002 M.-Nr. 05 853 730 / V This bio-friendly paper was bleached without the use of chlorine.