Miele DA 250-4 Installation Manual

Hide thumbs

Advertisement

Installation Instructions
DA 250-4 en-CA
Installation, repair and maintenance work should be performed by
a Miele authorized service technician in accordance with national
and local safety regulations and the provided installation instructions.

Advertisement

loading

  Summary of Contents for Miele DA 250-4

  • Page 1 Installation Instructions DA 250-4 en-CA Installation, repair and maintenance work should be performed by a Miele authorized service technician in accordance with national and local safety regulations and the provided installation instructions.
  • Page 2: Structural Support

    Structural support The ceiling mounting plate will support the weight of the hood. This ceiling plate must be attached to rigid structural framing that is supported in its entirety by the ceiling joists, or to the ceiling joists directly. Do not attach the plate directly to the ceiling with anchors, toggle bolts, etc.
  • Page 3: Electrical Data

    Circuit rating....15 A If there is any question concerning the electrical connection of this appliance to your power supply, please consult a licensed electrician or call Miele’s Technical Service Department. See back cover for contact information. WARNING:...
  • Page 4: Appliance Dimensions

    Appliance dimensions Exhaust connection 6" (150 mm) diameter 1) Entrance for ductwork and power cord...
  • Page 5: Installation

    Installation Do not install this exhaust hood over cooktops burning solid fuel. Provided a larger distance is not given by the manufacturer of the cooktop, follow the minimum safety distances between a cooktop and the bottom of the hood: - 22" (550 mm) above electric cooktops, - 30"...
  • Page 6: Installation Instructions

    Installation Installation instructions Installation accessories ^ See the enclosed installation instruction sheet. ^ Please read the "Important Safety Instructions" and Installation instructions before installing this 4 Screws 8 x 60 mm with hood. 4 Washers for securing the ceiling plate. (S8 wall anchors included in the packaging are not for use in USA) 2 Screws M 4 x 8 mm...
  • Page 7: Air Extraction

    INSTRUCTIONS" to reduce the risk of prevent condensation dripping into personal injury. Follow all local building the appliance. codes when installing the hood. – If the exhaust is ducted through an outside wall, a Miele Telescopic Wall Vent can be used.
  • Page 8: Condensate Trap

    Air extraction Condensate trap optional accessory In some cases, a condensate trap may be required to collect and evaporate any condensation which may develop. This optional accessory is available for ducts 5" (125 mm) and 5 " (150 mm) in diameter. –...
  • Page 9 Alteration rights reserved / 3306 M.-Nr. 06 850 870 / 00 en - US...