Charging The Battery; Filling The Engine With Oil; Product Overview - Toro Super Recycler 20797 Operator's Manual

1. Starter rope
Note: To make the rope easier to install, squeeze the
control bar on the handle.
3

Filling the Engine with Oil

No Parts Required
Procedure
Your mower does not come with oil in the engine.
1. Remove the dipstick (Figure 6).
2. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 6). Do
not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
3. Install the dipstick securely.
Important: Change the engine oil after the first
5 operating hours ; change it yearly thereafter.
Refer to Changing the Engine Oil.
Figure 5
2. Rope guide
Figure 6
4

Charging the Battery

No Parts Required
Procedure
Refer to the Charging the Battery in the Maintenance
section.

Product Overview

Self-propel model shown
1. Cutting height lever (4)
2. Spark plug
3. Air filter
4. Side discharge (not
shown)
5. Oil fill/Dipstick
6. Fuel tank cap
1. Grass bag
2. Side discharge chute
6
Figure 7
7. Recoil start handle
8. Blade control bar
9. Upper handle
10. Ignition key
11. Handle knob
12. Washout port
Figure 8
3. Rear discharge plug
(installed)
4. Battery charger