Changing The Engine Oil - Toro Super Recycler 20797 Operator's Manual

1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Use a screw driver to open the air filter cover
(Figure 34).
3. Replace the air filter.
4. Install the cover (Figure 35).

Changing the Engine Oil

Service Interval: After the first 5 hours
Every 50 hours
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Perform the pre-maintenance procedures; refer to
Preparing for Maintenance.
2. Remove the dipstick (Figure 36).
Figure 34
Figure 35
Figure 36
3. Tip the mower onto its side, with the air filter up,
to drain the used oil out through the oil fill tube
(Figure 37).
4. Slowly pour oil into the oil fill tube until the oil level
reaches the Full line on the dipstick (Figure 38). Do
not overfill. (Max. fill: 20 oz. (0.59 l), type: SAE 30
detergent oil with an API service classification of SF,
SG, SH, SJ, SL, or higher.)
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Charging the Battery
Service Interval: Every 25 hours
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the charger
in a sheltered area and charge the battery at room
temperature (70° or 22° C) whenever possible.
1. Connect the charger to the mower wire harness
located below the ignition key (Figure 39).
15
Figure 37
Figure 38