Bagging The Clippings; Installing The Grass Bag; Removing The Grass Bag - Toro Super Recycler 20797 Operator's Manual

Bagging the Clippings

Use the grass bag when you want to collect grass and
leaf clippings from the lawn.
WARNING
A worn grass bag could allow debris to be thrown
and result in serious personal injury or death to the
operator or bystanders.
Check the grass bag frequently. If it is damaged,
install a new Toro replacement bag.
If the side discharge chute is on the mower, remove it
and lock the side discharge door (refer to Removing the
Side Discharge Chute) before bagging the clippings.
WARNING
The blade is sharp; contacting the blade can result
in serious personal injury.
Stop the engine and wait for all moving parts to stop
before leaving the operating position.

Installing the Grass Bag

1. Route the starter rope around the lower rope guide
(Figure 20).
1. Lower rope guide
Note: The lower rope guide releases the starter rope
when you pull the recoil start handle.
2. Raise and hold up the discharge deflector (Figure 21).
Figure 20
1. Discharge deflector
3. Pull out the rear discharge plug (Figure 21).
4. Hang the upper front edge of the bag on the notches
(Figure 22).
1. Discharge deflector
5. Lower the discharge deflector.

Removing the Grass Bag

1. Route the starter rope around the lower rope guide
(Figure 23).
1. Lower rope guide
10
Figure 21
2. Rear discharge plug
Figure 22
2. Grass bag
Figure 23