Assembling And Unfolding The Handle; Installing The Starter Rope - Toro Super Recycler 20797 Operator's Manual

Setup
Important: Remove and discard the protective
plastic sheet that covers the engine.
1
Assembling and Unfolding the
Handle
No Parts Required
Procedure
WARNING
Assembling and unfolding the handle improperly
can damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when assembling and
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Raise the rear of the mower housing to its highest
cutting height setting by moving the 2 rear cutting
height levers all the way forward. Refer to Adjusting
the Cutting Height in the Operation section.
2. Attach the handle ends to the mower housing with
2 washers and 2 handle bolts (Figure 3), but do not
tighten the handle bolts.
1. Washer
2. Handle bolt
3. Rotate the handle rearward (Figure 4).
Figure 3
3. Handle end
4. Lock the handle at your desired height. Refer to
Adjusting the Handle Height in the Operation
section.
5. Torque the handle bolts to 120 to 160 in-lb (14 to
17 N-m).
6. Adjust the cutting height. Refer to Adjusting the
Cutting Height.
2

Installing the Starter Rope

No Parts Required
Procedure
Pull the starter rope through the rope guide on the
handle (Figure 5).
5
Figure 4