Battery/Charging Status - Electrolux PI92-4ANM Instruction Book

How to use the robot vacuum cleaner
Installation of the robot vacuum cleaner
1. Place the Charging base on the floor against the
wall. Plug the adaptor to the power jack on the
side of the base. Connect the Power cord plug to the
main socket. Wind up excessive cord on the back of
the base. Make sure there is an empty area of 0.5 m
on the sides and 1.5 m in front of the Charging base.
WiFi model: Place the base in range of the WiFi
router.
2. Place the side brush.
Note: If the robot is used to clean rooms with wall-to-
wall carpet, remove the side brush for best cleaning
results.t
3. Place the robot on the Charging base.
The Battery icon will pulse, to indicate that the
robot is recharging.

Battery/Charging status

1. Red battery (A) indicates that the robot needs to
get charged.
Red light pulse (B): The robot is charging – Low
charging level.
White light pulse (C):The robot has charged
enough to be used. (Press Play/Pause button to
clean.)
White light (D): The robot is ready for use.
Full charging time is ~ 3 hours.
www.electrolux.com
0.5 m
A B
0.5 m
1.5 m
C D
5