Initial Setup; User Set Setting - Samsung SV-2000M Owner's Instructions Manual

00872A SV-2000M/xev-GB1 9/8/56 12:10 PM Page 12
Inserting the Batteries in the Remote Control
GB
1

Initial Setup

* * COUNTRY SET * *
E U R O P E
A M E R I C A
A S I A / O C E A N I A
MIDDLE EAST/AFRICA
* * EUROPE * *
U . K G E R M A N Y
I T A L Y S P A I N
S W E D E N B E L G I U M
A U S T R I A R U S S I A
N E T H E R L A N D S
OTHERS M/G/I/K:M
M E M O R Y: O K
AUTO SET-UP WILL BE
S T A R T E D .
CHECK ANTENNA AND
TV CABLE CONNECTION.
P R O C E E D: O K
E N D: M E N U
AUTO SET UP
PLEASE WAIT
1 %
E N D: M E N U
12
You must insert or replace the batteries in the remote control when
you:
purchase the video cassette recorder ; or
find that the remote control is no longer working
correctly.
1
Push the tab in the direction of the arrow to release the battery
compartment cover on the rear of the remote control.
2
Insert two AAA or equivalent batteries (supplied), taking care to
respect the polarities.
+ on the battery with + on the remote control.
– on the battery with – on the remote control.
3
Replace the cover by aligning it with the base of the remote
control and pushing it back into place.
The VCR automatically displays the initial setup MENU when the
VCR is plugged into the AC outlet for the first time.
1
Plug the VCR into the AC outlet.
Result: The LANGUAGE SET is displayed.
2 Press the , and OK button to select your favorite language.
Result: The COUNTRY SETis displayed.
3
Press the , , button to select your country region.
Result: The country list is displayed.
4
Press the , , and OK button to select your country.
If your country does not appear in the country list, then
select OTHERS.
5
Press the OK button to store TV stations in the memory
automatically.
Connecting your VCR to the TV using the SCART cable.
6
It will automatically tune itself in and store TV stations in the
memory.
The process will finish after a few minutes.
Your VCR will then be ready for use.

USER SET Setting

The user set is initially set at the factory. If you want to make any
changes to the USER SET, please follow the instructions below.
1 Press the MENU button on the remote control.
Result: The MAIN menu is displayed.
2
Press the or button to select USER SET.
Result: The USER SETis displayed.
3 Press the OK button to select this options.
4
Check below to change the item.
ITEM USAGE COMMENT
OSD OSD display on/off Initial setting is on.
TAPE tape length selection Select the recording tape type for
SELECT remaining time.
COLOR COLOR SYSTEM To select NT3.58
SYSTEM or B/W selection NTPB or AUTO PAL
MESECAM B/W.
IPC Intelegent Initial mode is IPC ON.
Picture
Control
NICAM NICAM on/off Initial mode is NICAM ON
USER SET
O K E N D: M E N U
O S D : O N
TAPE SELECT :E 1 8 0 /
T 1 2 0
COLOR SYSTEM : A U T O
I P C : O N
N I C A M : O N
NT4.43
SECAM
E N D: M E N U
13
GB