SAFETY INSTRUCTIONS This STB has been manufactured to satisfy international safety standards. Please read the following recommended safety precautions carefully. MAINS SUPPLY AC 100-240V~, 50/60Hz OVERLOADING Do not overload wall outlets, extension cords or adapters as this can result in fire or electrical shock. LIQUIDS Keep liquids away from the STB.
CONNECTING YOUR “STB” 1. LOCATION OF THE RECEIVER Your STB should be placed under proper ventilation. Don’t put in completely enclosed cabinet that will restrict the flow of air, resulting in overheating. The location should be safeguarded from direct sunlight, excess moisture, rough handling or household pets.
3. Smart Card Slot 1 slot for Viaccess smartcard. N N o o t t e e : Smart Cards are only distributed by service providers and special distributors, not by SAMSUNG. GB-8 Rear Panel 1. CABLE IN 2. LOOP 3.
DESCRIPTION Remote Control Unit 1. POWER This is for switching the receiver ON/STANDBY mode. 2. 0-9 NUMERICAL keys These keys are to enter numeric values and to select the channel directly by entering its number. 3. PG+/PG- These keys are for moving up or down pages on the menu and TV/Radio list.
BASIC FUNCTIONS 1. Display Screen Before you can view the television program, you must perform the installation. Therefore you will see only menu images at first. After the television channels have been programmed, you will see the following picture(banner) each time you switch channels: Channel Number Signal Status Program Information...
Page 27
BASIC FUNCTIONS 5.1 Service Favorites ● Press the GREEN (TEXT) key on the control unit to select the Favorites list. ● Press the GREEN (TEXT) key to toggle group and channel list. ● Use the / , PG+/PG- keys to select a favorite group that you want.
BASIC FUNCTIONS 8. Teletext OSD When the current broadcasting program provides Teletext OSD, press the GREEN (TEXT) key twice to see the current Teletext OSD list. To change the Teletext OSD: ● Use the keys to select a Teletext OSD you want. ●...
OPERATING THE RECEIVER 1. Installation This menu consists of 3 sub-menus: Scan, Manual Scanning and Reset to Factory Defaults. ● Select “Installation” in the main menu mode to select the sub menu. ● Enter the PIN Code. If you have not entered your own PIN Code then the PIN Code 0000 applies, which was set at the factory.
OPERATING THE RECEIVER 2.2 Add and Remove Favorite Channels You can immediately register the present channel to the desired Favorite Group. In addition, you can register a channel to multiple favorite groups. ● Select the desired Favorite Group(FAV1~FAV9) using the FAV key. ●...
OPERATING THE RECEIVER 3.2 Change STB PIN code To change the PIN Code, select the second option “Change STB PIN code”. This will take you to the following menu: In this option, you need to enter the current PIN Code at the first cursor, and at the second cursor enter the desired PIN Code.
OPERATING THE RECEIVER 4.2 OSD Setting You can set the OSD transparency, the Banner Time, Color Scheme and OSD Position. ● Select OSD Transparency level. The OSD Transparency level from 0 to 100%. Setting is made with the numeric keys, keys or PG+/PG- keys.
OPERATING THE RECEIVER 4.4 Time & Timer Setting 1) Time ● Place the cursor on this sub menu. ● Press to change local time in Time Zone. GMT is referred to the standard time of Greenwich by broadcasting signal. This cannot be changed. 2) Timer 15 timers are supported including timer(s) from EPG.
TROUBLESHOOTING Problem Possible cause Solution of the problem No display LED on Power cord Power cord plug in correctly the front panel; not plugged in correctly No power supply No pictures on the screen Receiver in Standby mode; Set receiver to “On”; SCART not connected tightly Check connection and correct;...
Page 35
TECHNICAL SPECIFICATIONS BASE-BAND AUDIO/VIDEO OUTPUT VIDEO Video Type : Interface : 2 SCART (AV1, AV2) Impedance : 75Ω Output level : 1Vp-p AUDIO Interface : 2 SCART (TV, VCR) Impedance : 600Ω Output level : 3.0Vp-p max (controllable) Frequency response : 3dB (20~15kHz) DIGITAL AUDIO (S/PDIF) : Connector : Fiber-Optic...