D-Link DAP-1155 User Manual page 166

DAP-1155 Wireless N 150 Access Point & Router
User Manual
To activate the WPS function, select the WPS Enable checkbox and click the Change button.
When the checkbox is selected, the Information and Connection sections are available on the
page.
Parameter
Default PIN code
WPS Status
SSID
Network Authentication
Encryption
Encryption key
Refresh
Reset to unconfigured
WPS Method
PIN Code
Connect
The PIN code of the access point. This parameter is used when
connecting the access point to a registrar to set the parameters of the
WPS function.
The state of the WPS function:
Configured (all needed settings are specified)
•
Unconfigured (you need to specify the relevant settings).
•
The name of the access point's WLAN (or the first part of the
WLAN if the network is splitted into parts).
The network authentication type specified for the WLAN (or the first
part of the WLAN).
The encryption type specified for the WLAN (or the first part of the
WLAN).
The encryption key specified for the WLAN (or the first part of the
WLAN).
Click the button to refresh the data on the page.
Click the button to reset the parameters of the WPS function.
A method of the WPS function. Select a value from the drop-down
list.
PIN: Connecting the device via the PIN code.
PBC: Connecting the device via the push button (actual or virtual).
The PIN code of the WPS-enabled device that needs to be connected
to the wireless network of the access point.
The field is displayed only when the PIN value is selected from the
WPS Method drop-down list.
Click the button to connect the wireless device to the access point's
WLAN via the WPS function.
Page 166 of 215
Configuring Device (Router Mode)
Description