Safety, Environmental & Regulatory Information
3
Safety, Environmental & Regulatory Information
3.1
Scope
The present heading addresses Safety, Environmental & Regulatory Information about the FLB
3209 - 4G (APAC) extension card.
This extension card belongs to the same compliance frame than the base units. In the present
case of a telecommunication extension card, additional directives, standards and instructions
apply.
3.2
ESD Damage Prevention
The extension card described in this document is a module exposing both sides of an electronic
printed circuit board. Therefore, it is packed in an antistatic ESD bag. In order to avoid ESD
damage, the product must be handled with the necessary precaution including:
•
Grounded ESD protective work surface
•
Personnel grounding
3.3
Applicable Directives, Standards and Compliances
Applicable Safety Standards
3.3.1
The FLB 3209 fulfills the requirements of:
EN IEC 62368-1:2020 + A11:2020
UL 62368-1 Third Edition, revised October 22, 2021
CAN/CSA C22.2 No. 62368-1: 19 Third Edition, revised October 22, 2021
Certifications
3.3.2
The FLB 3209 has been certified with the following certifications:
•
Japan:
–
RadioAct (GITEKI(MIC)ID): 003-160025
–
elecomAct (JATEID): AD16-0014003
•
Malaysia: check
•
Thailand: check
•
South Korea: in progress
•
Australia/New Zealand: in progress
These certificates can be downloaded as PDF files on the Ewon support web site:
www.ewon.biz/support
FLB 3209 - 4G (APAC) Extension Card Installation Guide
Always use ESD precautions when handling extension cards and / or opened base unit as
they contain parts and assemblies susceptible to be damaged by electrostatic discharge
(ESD).
www.ewon.biz/support
www.ewon.biz/support
5 (18)
IG-0032-00 1.0 en-US