Subscribe to Our Youtube Channel
Related Manuals for HMS Networks Ixxat USB-to-CAN FD
Summary of Contents for HMS Networks Ixxat USB-to-CAN FD
- Page 1 USB-to-CAN Compact | Embedded | Automotive | PCIe Mini USER MANUAL 4.01.0350.20000 1.6 en-US ENGLISH...
- Page 2 HMS Networks reserves the right to modify its products in line with its policy of continuous product development. The information in this document shall therefore not be construed as a commitment on the part of HMS Networks and is subject to change without notice.
-
Page 3: Table Of Contents
Table of Contents Page User Guide ..............3 Target Audience . - Page 4 Technical Data ............19 Compact/Embedded/Automotive .
-
Page 5: User Guide
User Guide 3 (26) User Guide Please read the manual carefully. Make sure you fully understand the manual before using the product. Target Audience This manual addresses trained personnel who are familiar with CAN, CAN FD, LIN and the applicable standards. Only ESD trained staff is authorized to install the interface. -
Page 6: Trademark Information
User Guide 4 (26) Trademark Information ® Ixxat is a registered trademark of HMS Industrial Networks. All other trademarks mentioned in this document are the property of their respective holders. Conventions Instructions and results are structured as follows: ► instruction 1 instruction 2 ►... -
Page 7: Safety Instructions
Safety Instructions 5 (26) Caution This instruction must be followed to avoid a risk of personal injury. WARNING This instruction must be followed to avoid a risk of death or serious injury. Safety Instructions Risk of interference to radio and television if used in office or home environment! The product is a class B device. -
Page 8: Intended Use
Scope of Delivery 6 (26) Intended Use The interfaces are used to connect computer systems to CAN, CAN-FD and LIN networks. USB-to-CAN Embedded and PCIe Mini are intended for installation in computer systems with closed housing. The USB-to-CAN Compact and Automotive are intended for the connection to a computer via the USB interface. -
Page 9: Product Description
Product Description 7 (26) Product Description The USB-to-CAN is an active USB interface which enables the user to monitor and control up to two ISO CAN FD or non-ISO CAN FD or CAN High Speed channels and a LIN channel, depending on the variant. USB-to-CAN Compact/Embedded Fig. -
Page 10: Usb-To-Can Fd Automotive
Product Description 8 (26) USB-to-CAN Automotive Fig. 2 USB-to-CAN automotive • USB 2.0 Hi-Speed (480 MBit/s) • 2 x CAN FD interface with three operation modes: – ISO CAN FD according ISO 11898-1: 2015 – non-ISO CAN FD – CAN high-speed according ISO 11898-2: 2016 Operation mode can be set for each port individually. -
Page 11: Installation
Installation 9 (26) • USB 2.0 Hi-Speed (480 MBit/s) via PCIe Mini (if supported by computer in use) • galvanic CAN bus isolation • CAN FD interface with three operation modes: – ISO CAN FD according ISO 11898-1: 2015 – non-ISO CAN FD –... -
Page 12: Installing The Hardware
Installation 10 (26) Installing the Hardware 5.2.1 Connecting USB Connection disturbance possible if extension cable or longer cable is used! HMS recommends connecting the interface directly with the included cable or via an active USB hub to the computer according to the USB specification. - Page 13 Installation 11 (26) Damage of the equipment because of reverse polarity or wrong type of power supply! Make sure that the power supply is correctly connected and of recommend type. Connector: • USB cable with 5 pin female connector • Assignment corresponds to PC standard for internal USB devices.
-
Page 14: Connecting The Can Fieldbus
Installation 12 (26) USB-to-CAN PCIe Mini Fig. 5 PCIe connector Make sure that the computer in use supports USB via PCIe Mini. ► ► Make sure that the driver is installed. Turn off the computer. ► Pull the power cord. ►... - Page 15 Installation 13 (26) USB-to-CAN Compact/Embedded Pin Allocation Pin No. RJ45 Signal D-Sub 9 CAN high CAN low CAN GND 3, 7 3, 6 USB-to-CAN Automotive Pin Allocation RJ45, Pin No. Adapter cable CAN 1 Signal CAN 2/LIN D-Sub 9, Pin No. CAN high CAN low CAN GND...
- Page 16 Installation 14 (26) Pin Allocation PCIe Mini CAN FD Interface 1/2 Signal Pin No. Color CAN high CAN low Yellow CAN GND Black Pin Allocation PCIe Mini LIN Interface 3 Signal Pin No. Color VBAT Yellow LIN GND Black Connecting the Fieldbus If necessary install bus termination (see CAN Bus Termination, p.
-
Page 17: Connecting The Lin Fieldbus
Installation 15 (26) – Select predefined CAN FD bitrate in drop-down list Bitrate. With a predefined CAN FD bitrate the CAN FD standard bit timing and the CAN FD fast bit timing are specified and bit rate switching is enabled. Define the CAN messages to be transmitted in the transmit window of the ►... -
Page 18: Operation
Operation 16 (26) Operation The implemented LEDs vary dependent on the variant of the USB-to-CAN . The PCIe Mini has no LEDs. LED Arrays of the Different Variants Compact Automotive CAN1 CAN2 USB LED The USB LED reflects the status of the USB communication. LED state Description Comments... -
Page 19: Can Led
Operation 17 (26) CAN LED The CAN LEDs reflect the status of the CAN communication (CAN 1 and CAN 2). LED state Description Comments No communication No communication, device not connected to CAN Green Communication present LED is triggered with each message. flashing Red flashing Controller in error state... -
Page 20: Additional Components
Additional Components 18 (26) Additional Components CAN Bus Termination In the interface is no bus termination resistor for the CAN bus integrated. HMS Industrial Networks offers a bus termination resistor as a feed through connector. Fig. 7 CAN bus termination resistor ►... -
Page 21: Technical Data
Technical Data 19 (26) Technical Data Compact/Embedded/Automotive USB interface USB 2.0, Hi-Speed (480 MBit/s) Microcontroller/RAM/ 32 Bit/192 kByte/512 kByte Flash CAN controller/clock IFI CAN_FD IP/80 MHz frequency CAN bit rates 10 kbit/s to 1 Mbit/s CAN FD bit rates Arbitration rate: up to 1000 kbit/s, data rate: up to 8000 kbit/s (verified by testing) User defined bit rates are possible. -
Page 22: Pcie Mini
Technical Data 20 (26) PCIe Mini USB interface USB 2.0, Hi-Speed (480 MBit/s) via PCIe Mini connector Form factor F2: Full Mini with bottom-side keep outs According to PCI Express Mini Card Electromechanical Specification, Revision 1.2 CAN/LIN connector SM03B-SURS-TF by JST (counterpart is 03SUR-32S by JST) type Pre-assembled open-style cable for each CAN and LIN connector is included. -
Page 23: Troubleshooting
Troubleshooting 21 (26) Troubleshooting USB LED is off after installation. Make sure that the device is correctly ► No communication connected to the USB port. ► Check the power supply. ► Make sure that device and driver are correctly initialized. Make sure that the correct driver version ►... -
Page 24: Support/Return Hardware
22 (26) Support/Return Hardware Support/Return Hardware 11.1 Support ► To contact support, go to www.ixxat.com/technical-support/contact-technical-support. Scroll down and click button mysupport.hms.se to register a support case. ► 11.2 Return Hardware www.ixxat.com/support/product-returns click button Portal to access ► the support portal. ►... -
Page 25: A Regulatory Compliance
Appendix A: Regulatory Compliance 23 (26) Regulatory Compliance EMC Compliance (CE) The product is in compliance with the Electromagnetic Compatibility Directive. More information and the Declaration of Conformity is found at www.ixxat.com. EMC Compliance (UKCA) The product is in compliance with the Electromagnetic Compatibility Regulations 2016. - Page 26 Appendix A: Regulatory Compliance 24 (26) Any changes or modifications not expressly approved by HMS Industrial Networks could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
-
Page 27: Disposal And Recycling
Appendix A: Regulatory Compliance 25 (26) Disposal and recycling You must dispose of this product properly according to local laws and regulations. Because this product contains electronic components, it must be disposed of separately from household waste. When this product reaches its end of life, contact local authorities to learn about disposal and recycling options, or simply drop it off at your local HMS office or return it to HMS. - Page 28 last page © 2021 HMS Industrial Networks Box 4126 300 04 Halmstad, Sweden info@hms.se 4.01.0350.20000 1.6 en-US / 2021-10-15 / 23587...
Need help?
Do you have a question about the Ixxat USB-to-CAN FD and is the answer not in the manual?
Questions and answers