Table of Contents
Advertisement
Plug the FLB 3209 into the Base Unit
5.3
Extension Card Insertion
5.3.1
How to Insert into the Flexy Base Unit
Wait 30 seconds after turning off the equipment before inserting (or removing) an extension
card to avoid possible damage to the base unit and the extension cards.
Remove the slot filler of the location the new card will be inserted. To do so, press on both ends
of the cover, note that the hooks are off-centered.
Fig. 7
Remove the slot fillers
1
2
Insert the extension card carefully and slide it down until the hook clicks. Make sure the card is
completely inserted.
DO NOT insist if a resistance is felt when trying to insert the card. This can occur if the extension
card is inserted in a wrong slot type. In such case, check slot compatibility of the relevant
extension card.
Boot the unit for the inserted extension cards to be detected. The web interface of the Flexy
base unit has a diagnostic page showing the extension cards in their order of detection (from left
to right).
FLB 3209 - 4G (APAC) Extension Card Installation Guide
Hooks to be pressed are off-centered. Press while pulling upwards
This metal tag soldered on the PCB acts as mistake-proof security (mating stop in housing).
Doesn't apply on Flexy 205.
If an extension card is inadvertently forced in a wrong slot, the base unit will detect the
misplaced card and will not complete its boot process. Therefore, the unit will not be
accessible through its LAN interface. The slot error is returned by the USR LED. (red ON 1
sec, OFF 0.5 sec).
13 (18)
IG-0032-00 1.0 en-US
Advertisement
Table of Contents
