Table of Contents
Advertisement
Hardware Description
Item
1
2
3
4
The LEDs represent only the signal level and not the type of technology used to perform a connection.
During the modem boot process, all 4 LEDs are steady orange. If they stay orange, it means the
modem card was inserted in a wrong slot. This induces a base unit boot error pattern on its USR
LED as well.
If all signal level LEDs are off, it either means that:
•
the modem was not configured
•
the modem configuration is invalid (including wrong PIN-code)
•
there is no signal at all (level 0)
•
there is a reception error (level 99)
4.4
Specifications of the FLB 3209
Item
Bands & Frequencies
Tx Output Power
Antenna Connector
Antenna
(not included)
Device conformity assessment has been performed with the reference antenna: Taoglas Olympian G30.B108111
1.
4G antenna has to be purchased separately. HMS Industrial Networks SA offers such antenna under "FAC90801_0000"
reference.
FLB 3209 - 4G (APAC) Extension Card Installation Guide
Mark
Function
STAT
Tricolor: Red / Orange / Green
Green ON = Modem is online
Reception Signal level
▅
Orange ON = level > 1 (poor signal)
Reception Signal level
▅ ▆
Orange ON = level > 10 (signal ok)
Reception Signal level
▅ ▆ ▇
Orange ON = level > 16 (good signal)
Value(s)
LTE: B1, B3, B5, B7, B8, B18,B19,B21,B28,B38,B39,B40,B41
UMTS: B1, B5, B6, B8, B9, B19
LTE Band 1, 3, 5, 8, 18, 19, 21, 28, 39: Class 3 (0.25W);
LTE Band 7, 38, 40, 41: Class 3 (0.2W);
UMTS all Bands: class 3 (0.25W)
Type SMA-F Female
Characteristic
Impedance
VSWR
Input Power
Tightening Torque
This device is intended to be used only in fixed applications. The antenna used for this
transmitter has to be installed to provide a distance of at least 20 cm from any person
and may not be co-located or operating in conjunction with any other antenna or
transmitter.
Value(s)
50 Ohms
<= 3:1 Absolute maximum limit
<= 2:1 Limit to fulfill all regulatory
requirements
> 33 dBm (2W) peak power in GSM
> 24 dBm average power in WCDMA
0.5 Nm
In the absence of a torque wrench, a soft
manual tightening is sufficient.
IG-0032-00 1.0 en-US
8 (18)
1
Advertisement
Table of Contents
