R&S RT-ZM User Manual page 31

®
R&S RT‑ZM
Connecting the tip cable into the probe amplifier
1. NOTICE! Keep the R&S RT‑ZM probe amplifier outside the temperature
chamber. It has a specified operating temperature range from 0°C to 40°C.
Connect the R&S RT‑ZMA11 tip cable solder-in ET to the 1-m extension cable
pair.
2. Connect the other end of the extension cable pair to the R&S RT‑ZM probe
amplifier.
Measurements in MultiMode
In this configuration, you can measure single-ended, differential and common
mode signals without resoldering the tip cable.
1. Solder both signal leads (P,N) in front of tip board and to the DUT.
User Manual 1419.3128.02 ─ 05
Connecting the probe
Connecting the probe to the DUT
31