R&S RT-ZM User Manual page 23

®
R&S RT‑ZM
Measurements in MultiMode
In this configuration, you can measure single-ended, differential and common
mode signals without resoldering the tip cable.
1. Solder both signal leads (P,N) in front of the tip board and to the DUT.
2. Solder both ground wires (GND) at the outside of the tip board and to the
DUT.
Measurements in DM mode
In this configuration, you can measure only differential measurements.
1. Solder both signal leads (P,N) to your DUT.
2. Leave ground vias open.
User Manual 1419.3128.02 ─ 05
Connecting the probe
Connecting the probe to the DUT
Bandwidth: up to 16 GHz
MultiMode compatible
Length: 15 cm
Variable span range of the leads: 0 mm to
5 mm (0 mil to 200 mil).
Temperature range: -30 °C to +80 °C
23